Miele T 8164 WP operating instructions Correct use

Page 9

Warning and Safety instructions

Please observe all instructions given in "Installation and connection" and in "Technical data".

The accessibility of the plug must be always ensured, in order to separate the tumble dryer from the mains.

Do not block the gap between the bottom of the tumble dryer and the floor with plinth facings, deep pile carpet etc. This would hinder a sufficient flow of air to the dryer.

Make sure the dryer door can be opened without hindrance after installation.

Correct use

The maximum load for this tumble dryer is 7.0 kg (dry weight). The maximum recommended loads for individual programmes are given in the Programme chart.

To prevent the risk of fire, do not connect the tumble dryer via a controllable socket (e.g. a timer or a peak-load switch-off device). If the drying programme is interrupted before the end of the cooling down phase, laundry could self-ignite.

9

Image 9
Contents Operating instructions Heat-pump dryer 8164 WP Disposal of the packing material Caring for the environmentDisposal of your old appliance Energy saving tipsContents Contents Correct application Safety with children Technical safety Page Correct use Page Page Page Accessories Control panel Operating the tumble dryerDisplay h min Before using for the first timeDrum lighting Display showsLaundry care Care symbolsTips on drying DryingBrief instructions How to dry correctly Sort the laundry  Turn on the tumble dryer Remove the laundry when the programme has finished  Select a programme Start the programme Once a programme has started Changing the programme sequenceAdding or removing laundry after a programme has started Programme durationCottons Max. load 7.0 kg Normal+, Normal Programme overviewNormal Gentle tumble Hand iron, Machine ironAutomatic plus Max. load 3.5 kg Minimum iron Max. load 3.5 kg Normal, Hand ironTimed drying Max. load 7.0 kg Min warm air Min cool airWoollens Max. load 2.0 kg Gentle smoothing Max. load 1.0 kgEmptying the condensed water container Cleaning and careWhen to clean the fine filter When to clean the fluff filtersCleaning the fluff filters When to cleanCleaning them whilst dry Cleaning them with water Replacing them Cleaning the fine filter Fine filterRemoving the fine filter Cleaning the cover for the fine filter Replacing Tumble dryerCheck and fault messages Problem solving guideThere is a build-up of fluff in the airways Problem solving guideUnsatisfactory drying results Other problems Even switches off Problem Cause and remedy Drying processGoes on too long or Before starting another programmeChanging the lamp Guarantee After sales serviceRepairs Dryer basketFront view Installation and connectionTransporting the dryer Rear viewInstallation Before moving the tumble dryer again e.g. when moving house Levelling the dryerWasher-dryer stack Electrical connection U.K Non-rewireable plugs BSAutomatic plus Consumption dataTechnical data Page Settings To check the setting Laundry will be drier  Carry out steps -  Switch the dryer off after checking Anti-crease  Anti-crease action off  Anti-crease 1 h Anti-crease 2 h Switching the buzzer on/off Clean out airways indicator light will also flash once Not in current programme factory default setting StandbyOff  Off  On  Not in current programme factory default settingGentle smoothing Adjusting the dryers electronics for very soft waterPage Page Page Alteration rights reserved/4613 Nr 557 600