Miele T 8164 WP operating instructions Rear view, Transporting the dryer

Page 38

Installation and connection

Rear view

aProtruding lid for holding when moving the dryer (see arrows)

bMains connection cable

Transporting the dryer

To manoeuvre the dryer out of its packing case to its installation site,

hold it by the front feet

as well as by the edge of the lid where it protrudes to the rear of the dryer.

Only transport the dryer as

shown in the following illustrations.

If transporting the dryer at an angle, only tip towards the left side.

If the tumble dryer has not been transported as described, then it must be left to stand for at least 1 hour before it is connected to the electricity supply. Otherwise the heat pump can be damaged.

38

Image 38
Contents Operating instructions Heat-pump dryer 8164 WP Disposal of your old appliance Caring for the environmentDisposal of the packing material Energy saving tipsContents Contents Correct application Safety with children Technical safety Page Correct use Page Page Page Accessories Operating the tumble dryer Control panelDrum lighting Before using for the first timeDisplay h min Display showsTips on drying Care symbolsLaundry care Drying Sort the laundry How to dry correctlyBrief instructions  Turn on the tumble dryer Start the programme  Remove the laundry when the programme has finished Select a programme Adding or removing laundry after a programme has started Changing the programme sequenceOnce a programme has started Programme durationNormal Gentle tumble Programme overviewCottons Max. load 7.0 kg Normal+, Normal Hand iron, Machine ironTimed drying Max. load 7.0 kg Min warm air Minimum iron Max. load 3.5 kg Normal, Hand ironAutomatic plus Max. load 3.5 kg Min cool airGentle smoothing Max. load 1.0 kg Woollens Max. load 2.0 kgCleaning and care Emptying the condensed water containerWhen to clean the fluff filters When to clean the fine filterCleaning them whilst dry Cleaning the fluff filtersWhen to clean Cleaning them with water Replacing them Removing the fine filter Cleaning the fine filterFine filter Cleaning the cover for the fine filter Tumble dryer ReplacingProblem solving guide Check and fault messagesProblem solving guide There is a build-up of fluff in the airwaysUnsatisfactory drying results Other problems Goes on too long or Problem Cause and remedy Drying processEven switches off Before starting another programmeChanging the lamp Repairs After sales serviceGuarantee Dryer basketInstallation and connection Front viewRear view Transporting the dryerInstallation Washer-dryer stack Before moving the tumble dryer again e.g. when moving houseLevelling the dryer Non-rewireable plugs BS Electrical connection U.KConsumption data Automatic plusTechnical data Page  Laundry will be drier SettingsTo check the setting  Carry out steps -  Switch the dryer off after checking  Anti-crease 2 h Anti-crease Anti-crease action off  Anti-crease 1 h Switching the buzzer on/off Clean out airways indicator light will also flash once Off Not in current programme factory default settingStandby  On  Not in current programme factory default setting  OffAdjusting the dryers electronics for very soft water Gentle smoothingPage Page Page Alteration rights reserved/4613 Nr 557 600