Installation and connection
Levelling the dryer
The appliance must stand perfectly level on all four feet to ensure safe and proper operation.
The screw feet can be adjusted to compensate for any unevenness in the floor.
Do not block the gap between the bottom of the tumble dryer and the floor with plinth facings, deep pile carpet etc. This would hinder a sufficient flow of air to the dryer.
Before moving the tumble dryer again (e.g. when moving house)
After each use a small quantity of condensed water will collect in the area of the pump. This water can run out if the tumble dryer is tipped up when it is being moved. It is a good idea to run the Warm air programme for approximately 1 minute before moving the tumble dryer. Any remaining condensed water will then be fed into the condensed water container or out through the drain hose.
Washer-dryer stack
The tumble dryer can be combined with a Miele washing machine in a washer- dryer stack. The appropriate "WTV" stacking kit* to match your dryer is required.
*Miele accessory available to order
Stacking kits must only be installed by a suitably qualified fitter.
40