Miele T 8164 WP operating instructions

Page 8

Warning and Safety instructions

The tumble dryer must be isolated from the electricity supply in the event of a fault and during cleaning and maintenance.

This tumble dryer must not be used in a non-stationary location (e.g. on a ship).

Do not make any alterations to the tumble dryer, unless authorised to do so by Miele.

Heat pump technology and refrigerant:

The heat pump in this tumble dryer uses a refrigerant which is condensed by the compressor and led in a closed circuit through the heat exchanger unit where heat exchange with the circulating drying air takes place.

The humming noises caused by the heat pump are normal and do not impair the efficient functioning of the dryer.

The refrigerant is not flammable or explosive.

In general it is not necessary to leave the dryer standing for any length of time before it is connected to the mains provided it has been transported and installed correctly (see "Installation and connection - Transporting the dryer"). However, if it has not been transported as described, ensure that the recommended standing time prior to first operation is observed. Otherwise the heat pump can be damaged.

8

Image 8
Contents Operating instructions Heat-pump dryer 8164 WP Caring for the environment Disposal of the packing materialDisposal of your old appliance Energy saving tipsContents Contents Correct application Safety with children Technical safety Page Correct use Page Page Page Accessories Operating the tumble dryer Control panelBefore using for the first time Display h minDrum lighting Display showsCare symbols Laundry careTips on drying DryingHow to dry correctly Brief instructions Sort the laundry  Turn on the tumble dryer Start the programme  Remove the laundry when the programme has finished Select a programme Changing the programme sequence Once a programme has startedAdding or removing laundry after a programme has started Programme durationProgramme overview Cottons Max. load 7.0 kg Normal+, NormalNormal Gentle tumble Hand iron, Machine ironMinimum iron Max. load 3.5 kg Normal, Hand iron Automatic plus Max. load 3.5 kgTimed drying Max. load 7.0 kg Min warm air Min cool airGentle smoothing Max. load 1.0 kg Woollens Max. load 2.0 kgCleaning and care Emptying the condensed water containerWhen to clean the fluff filters When to clean the fine filterCleaning them whilst dry Cleaning the fluff filtersWhen to clean Cleaning them with water Replacing them Removing the fine filter Cleaning the fine filterFine filter Cleaning the cover for the fine filter Tumble dryer ReplacingProblem solving guide Check and fault messagesProblem solving guide There is a build-up of fluff in the airwaysUnsatisfactory drying results Other problems Problem Cause and remedy Drying process Even switches offGoes on too long or Before starting another programmeChanging the lamp After sales service GuaranteeRepairs Dryer basketInstallation and connection Front viewRear view Transporting the dryerInstallation Washer-dryer stack Before moving the tumble dryer again e.g. when moving houseLevelling the dryer Non-rewireable plugs BS Electrical connection U.KConsumption data Automatic plusTechnical data Page  Laundry will be drier SettingsTo check the setting  Carry out steps -  Switch the dryer off after checking  Anti-crease 2 h Anti-crease Anti-crease action off  Anti-crease 1 h Switching the buzzer on/off Clean out airways indicator light will also flash once Off Not in current programme factory default settingStandby  On  Not in current programme factory default setting  OffAdjusting the dryers electronics for very soft water Gentle smoothingPage Page Page Alteration rights reserved/4613 Nr 557 600