11.5 Reporting Options Tab
The Reporting Options tab displays fi
Report AC Fail
The default REPORT AC FAIL setting enables AC power failure and restore reports with a random delay of up to one hour. Alternately, the Console can be set to report AC power status without the random delay, or be disabled.
Three options are available for AC failure reporting.
•The DISABLE setting will inhibit AC failure reporting.
•The ENABLE setting will report when the Console has been without AC power for fi ve minutes. A restore report will be sent fi ve minutes after AC power is restored.
•The ENABLE (RANDOM DELAY UP TO 1 HOUR) settings functions the same as the ENABLE setting, except that any reports will occur at a random time up to one hour from the event. This option can reduce collisions of Central Station traffi c caused by a
When the AC power status changes, after the fi ve minute wait period, the Console will announce:
0“Console power failure”
— OR —
0“Console power restored”
Report Supervisory Events
The default is to report supervisory events to the Central Station. The events will be reported to the primary/secondary telephone number unless split reporting is enabled, which would cause the reports to go to the supervisory telephone number.
Mode Switch Reporting
The Console can report to the Central Station when the Console is switched between Home Mode and Away Mode.
The default MODE SWITCH REPORTING setting does not report mode changes to the Central Station. To report mode changes, check this option box.
Answer Phone
The default enables ring detection on the telephone line connected to the Console.This setting must be on to support the remote RA4200 telephone programming, remote limited
If these features are not required or used, ring detection can be disabled by
RA4200 Reporting Options Tab
21