Linear PERS-4200 Series manual Learning a Single Sensor, Erasing All Sensors, Testing Sensors

13.2 Learning a Single Sensor

Learn Sensor Mode may also be entered by pressing and holding the CANCEL button for fi ve seconds. The Console will announce:

0“Ready to learn sensor... Zone [number]”.

Activate the sensor to learn. The Console will announce:

0“[Fire, Activity, Emergency, or Carbon Monoxide] sensor learned”.

The Console will exit Learn Sensor Mode after learning one sensor. To exit without learning a sensor, press the CANCEL button.

13.3 Erasing All Sensors

To erase ALL sensors, press and hold TEST button for fi ve seconds. The Console will announce:

0“Zones reset”

All learned sensors are erased by this operation. The Console will then go to normal operation and announce:

0“Console ready”

✓NOTE: Any pending alarms or events for an erased zone will be cleared.

13.4 Testing Sensors

Each sensor learned into the Console should be tested. When a sensor is tested, the Console will announce the type of sensor, the zone number, and the RF signal level.

✲IMPORTANT! AFTER CONSOLE INSTALLATION, PORTABLE SENSORS SHOULD BE TESTED IN VARIOUS PLACES ON-LOCATION TO DETERMINE THE EFFECTIVE RADIO RANGE OF THE SYSTEM.

Use the following steps to test each system sensor.

1.Press and release the TEST button (located recessed on the bottom of the Console). The Console will announce:

0“Test Mode... firmware version [number]...

hardware version [number]”.

2.Activate each sensor to test. For each sensor, the Console will announce:

0“[Fire, Activity, Emergency, or Carbon Monoxide] sensor... zone [number]... [full or low] signal”.

If the sensor tested has a low battery, the Console will announce:

0“Sensor low battery... zone [number]”

3. When fi nished, press CANCEL to exit Test Mode (Test Mode will automatically exit after three minutes of inactivity).

"EMERGENCY SENSOR.... ZONE ONE... FULL SIGNAL"
PERS-4200
CONSOLE
IN TEST MODE
		TEST ALL SENSORS
PRESS TEST BUTTON		PROGRAMMED INTO
		THE CONSOLE
TO ENTER TEST MODE
	IMPORTANT!
	TEST SENSORS FROM VARIOUS
	LOCATIONS IN THE INSTALLATION
BOTTOM OF	TO VERIFY THE EFFECTIVE RADIO RANGE
PERS-4200
CONSOLE

Testing System Sensors

30