Philips 545, 555 Every three months, Keep the guard and cutter together because, Every six months

Every three months

If your skin is of an oily type or if you have been using a pre- shave lotion, this procedure should be carried out once a month.

Fig. 6.	Pull the shaving unit from the shaver.
Fig. 7.	Press the wheel downward and turn it anti-clockwise
	(see the arrow). Then lift the cluster frame holding
	the shaving heads from the shaving unit.
Fig. 8.	Slide one shaving head (guard and cutter) out of the
	frame. Keep your finger under the shaving head to
	prevent the cutter from falling out of the guard.
Fig. 9.	Keep the guard and cutter together because
	each pair has been especially ground to match
	each other. If the guards and cutters are mixed, it
	may take a couple of weeks before optimal shaving
	performance is restored.
Fig. 10.	Hold the cutter as shown...
Fig. 11	....and brush it carefully clean as illustrated.
	Use only the short bristled end of the brush.
Fig. 12.	Clean the inside of the guard, using the long bristled
	end of the brush.
Fig. 13.	Slide the shaving head back into place. Then clean
	the other two shaving heads one by one in the
	same way.
Fig. 14.	Replace the cluster frame with the shaving heads.
	Do not forget to secure the cluster frame by
	pressing the wheel downward and turning it
	clockwise.
Fig. 15.	Do not apply any pressure to the guards when
	replacing the shaving unit.
Fig. 16.	If you have used a degreasing liquid (e.g. alcohol) to
	clean the shaving heads, or if your skin is very dry,
	lubricate the guards with one drop of light machine
	oil.

Every six months

Fig. 17. Put two drops of light machine oil on the teeth of the trimmer.

6