Invacare T6 manual Adjusting/Replacing Standard Footrest, Replacing the Footrest

SECTION 4—FOOTREST

SECTION 4—FOOTREST

WARNING

After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely - otherwise injury or damage may occur.

ALWAYS perform this procedure in the presence of an assistant. The position of the footrest, camber tube, back angle, the tautness of the back upholstery as well as the user's condition are directly related to the wheelchairs stability. Any change to one or any combination of the five may cause the wheelchair to decrease in stability. Use EXTREME caution when using a new seating position. The addition of anti-tippers may be required.

Check ALL allen screws that secure the footrest/raised footrest system to the wheelchair frame to make sure they are securely tightened BEFORE using the wheelchair. ESPECIALLY if engaging in ANY contact sport.

The footrest assembly MUST be at least 1-3/4-inches (4.45 cm) above the ground/floor to avoid hitting protruding objects when using this wheelchair.

Adjusting/Replacing Standard Footrest

NOTE: For this procedure, refer to FIGURE 4.1.

1.Loosen the allen screw of the two clamps that secure the footrest to the wheelchair frame.

Replacing the Footrest

1.Remove existing footrest.

2.Install new footrest.

Clamps (Allen Screws)

Wheelchair

Frame

Footrest

FIGURE 4.1 Adjusting/Replacing Standard

Footrest

WARNING

The standard footrest has an open hoop. A footplate cover is recommended for wheelchair users that have leg spasticity or whose feet have a possibility of falling through the footrest hoop. A calf strap is provided with each wheelchair to prevent the feet from slipping backwards off of the footrest. Be sure the calf strap is secure when using the wheelchair.

Adjusting the Footrest

1.Position new/existing footrest to desired height.

2.Tighten the allen screw of the two clamps that secure the footrest to the wheelchair frame.

Part No 1148078 25 Crossfire™Series Wheelchairs