Invacare T6 manual Replacing Anti-tipper, Part Number

SECTION 10—ANTI-TIPPER

Replacing Anti-tipper

WARNING

When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to

2-inch (3.81 and 5.08 cm) clearance between the bottom of the anti-tipper wheels and the ground/floor. This spacing should always be checked whenever adjust- ments/changes are made to the wheelchair. Failure to maintain proper spacing may result in the chair tipping over backward causing serious injury or property damage.

1.Press in the release button that secures the existing anti-tipper to the anti-tipper socket and remove the anti-tipper from the anti-tipper socket.

2.Insert the new anti-tipper into the anti-tipper socket until release button engages.

3.Press in the release button on the anti-tipper bar and install the anti-tipper wheels onto the new anti-tipper bar.

4.Repeat STEPS 1-3 for the opposite anti-tipper.

5.Measure the distance between the bottom of the anti-tipper wheels and the ground floor.

6.If necessary, adjust the height of the anti-tippers. Refer to Adjusting Anti-tipper on page 58.

PART NUMBER	MEASUREMENT
1112178	21 - 1/8-inches
	(53.66 cm)

DETAIL “A” - ANTI-TIPPER

ADJUSTMENT HOLES

Top Adjustment Hole

Anti-Tipper Bar	Release
	Button

Release Buttons

Anti-Tipper
Ground/	1-1/2 to 2 inch	Anti-Tipper
	(3.81 and 5.08 cm)		Hole
Floor	Clearance

Anti-Tipper Socket

FIGURE 10.1 Adjusting/Replacing Anti-tipper

Part No 1148078 59 Crossfire™Series Wheelchairs