Invacare T6 manual Back Angle Adjustment

SECTION 6—BACK

1.Loosen, but DO NOT remove the locknuts and hex screws that secure the back angle bracket to the seat rail and the back cane.

2.Loosen the top locknut and slide the top hex screw away from the back angle bracket to adjust the cam.

3.Adjust back canes to back angle required.

4.Adjust cam to achieve desired position.

NOTE: An indexing notch has been put on the cam to help determine cam position for desired back angle adjustment.

5.Secure cam in desired position. Torque all hex screws and locknuts to 960-1020 inch pounds (80-85 foot-pounds) (1105920 - 1175040 gram-centimeters).

NOTE: As shown in FIGURE 6.2, the adjustment cam can be rotated to several different positions thus changing the overall back angle relative to the seat rail.

95° Back Angle to Seat Rail				90° Back Angle to Seat Rail
Back Cane		Indexing		Back Cane	Indexing
TOP Hex		Notch			Notch
				TOP Hex Screw
Screw and
				and Locknut
Locknut
			Cam	Back Angle	Cam
Back Angle				Bracket
Bracket
		Seat Rail		Seat Rail
85° Back Angle to Seat Rail				80° Back Angle to Seat Rail
Back				Back Cane
Cane	Indexing Notch			Indexing
				Notch
				TOP Hex
				Screw and
TOP Hex Screw				Locknut
and Locknut			Cam		Cam
Back Angle Bracket				Back Angle Bracket
		Seat Rail		Seat Rail

75° Back Angle	Back Cane	Indexing
to Seat Rail		Notch

TOP Hex Screw	Cam
and Locknut
Back Angle Bracket	Seat Rail

FIGURE 6.2 Back Angle Adjustment

Part No 1148078 31 Crossfire™Series Wheelchairs