SECTION
Back Height Adjustment (Adjustable Backs Only)
NOTE: For this procedure, refer to FIGURE 6.5
NOTE: Observe the tautness of the back upholstery for reinstallation.
1.Unlatch the two fastening flaps that secure the top of the back upholstery to the back canes and remove from the back canes.
WARNING
Adjustment pin MUST be protruding through hole in back cane.
Ensure that both back cane inserts are at the same height BEFORE reassembling the wheelchair.
2.Press the adjustment pin on the back cane insert tube in and adjust the back height to one of four heights depending on original back height:
HOLE* NUMBER | BACK HEIGHT IN INCHES AND CENTIMETERS | ||
|
|
| |
| (20.32 - 27.94 CM) | (25.4 - 35.56 CM) | (35.56 - 45.72 CM) |
| 8 - 11 | 10 - 14 | 14 - 18 |
|
|
|
|
1 | 8 (20.32 cm) | 10 (25.4 cm) | 14 (35.56 cm) |
|
|
|
|
2 | 9 (22.86 cm) | 11 (27.94 cm) | 15 (38.1 cm) |
|
|
|
|
3 | 10 (25.4 cm) | 12 (30.48 cm) | 16 (40.64 cm) |
|
|
|
|
4 | 11 (27.94 cm) | 13 (33.02 cm) | 17 (43.18 cm) |
|
|
|
|
5 | NA | 14 (35.56 cm) | 18 (45.72 cm) |
|
|
|
|
*NOTE: Holes numbered from bottom to top for reference only. (There are no numbers on the back canes.)
3. Reinstall the fastening flaps onto the back canes.
NOTE: The fastening flap with logo is for the left back cane.
NOTE: Right and left is determined by sitting in the wheelchair.
4.Adjust the new back upholstery to the desired tautness. Refer to Back Height Adjustment (Adjustable Backs Only) on page 35.
Insert
Adjustment Pin 
| Hole Number | |
| 5 | |
Back | 4 | |
3 | ||
Cane | ||
| 2 | |
| 1 |
FIGURE 6.5 Back Height Adjustment (Adjustable Backs Only)
Part No 1148078 | 35 | Crossfire™Series Wheelchairs |