Invacare T6 manual Changing Wheel Lock Handle Position, Replacing/Adjusting the Wheel Locks

SECTION 9—WHEEL LOCKS

Push-to-Lock or Pull-to-Lock Wheel Locks	Under Mount Wheel Lock
Mounting Screws 3/16 inch (.47 cm)	Mounting Screws	3/16 inch (.47 cm)
(1/8-inch) (.32 cm)		(1/8-inch) (.32 cm)

Wheel	Tyre	Wheel	Wheel Lock	Wheel
Lock				Lock Shoe
		Lock Shoe	Tyre

FIGURE 9.1 Replacing/Adjusting the Wheel Locks

Changing Wheel Lock Handle Position

NOTE: For this procedure, refer to FIGURE 9.2.

1.Loosen, but DO NOT remove, the rear handle mounting screw.

2.Remove the front handle mounting screw and locknut.

3.Align the front handle mounting hole with one of three desired mounting positions on the wheel lock.

4.Using the front handle mounting screw

and locknut, secure the handle to the wheel lock.

Wheel lock Handle

Mounting

Positions

5.Securely tighten the front and rear handle mounting screws and locknuts.

6.Repeat STEPS 1-5 on remaining wheel lock handle.

Rear Handle	Front Handle
	Mounting
Mounting
	Screw and
Screw
	Locknut

FIGURE 9.2 Changing Wheel Lock Handle

Position

Crossfire™Series Wheelchairs 56 Part No 1148078