SECTION
Adjusting the Camber Tube
WARNING
STANDARD and axle tube clamps - Make sure the hex screws are securely tight- ened before using the wheelchair, otherwise injury or damage to the wheelchair may occur.
NOTE: For this procedure, refer to FIGURE 8.12.
Stand behind the wheelchair to determine left or right.
1.Loosen, but DO NOT remove the four socket screws camber tube clamps.
2.Using an "L" square, rotate the axle tube until the flat edge of the camber tube is at a 90° angle with the ground/floor.
3.Securely tighten the four socket screws camber tube clamps.
4.Determine the toe in/toe out of the wheelchair. Refer to Adjusting Wheelbase Length (Adjusting Center of Gravity) on page 42.
Flat Edge of Camber Tube
(Place “L” Square Here)
“L” Square Here
(90° Angle)
Ground/
Floor
FIGURE 8.12 Adjusting the Camber Tube
Crossfire™Series Wheelchairs | 48 | Part No 1148078 |