SECTION
Adjusting Swingaway Padded Armrest Height
NOTE: For this procedure, refer to FIGURE 5.2.
1.Remove the half arm from the arm socket.
2.Remove the mounting bolt, two washers and locknut mounted in the arm socket that determine the swingaway padded armrest height.
3.Reposition mounting bolt and one washer to one of three positions in the arm socket depending on the desired height.
4.Retighten the mounting bolt and washer to the arm socket with the remaining washer and locknut.
5.Reinstall the half arm into the arm socket.
6.Repeat STEPS
Swingaway Padded Armrest
Arm Socket
Washer
Locknut | Washer |
Mounting Bolt Three Mounting Positions
FIGURE 5.2 Adjusting Swingaway Padded Armrest Height
Part No 1148078 | 29 | Crossfire™Series Wheelchairs |