Leica dm750 p manual Information for the person responsible for the instrument

Page 11

Information for the person responsible for the instrument

Information for the person responsible for the instrument

ϘϘ Ensure that the Leica DM750 P microscope is used only by qualified personnel.

ϘϘ Ensure that this user manual is always avail- able at the Leica DM750 P microscope.

ϘϘ Carry out regular inspections to make certain that the authorized users are adher- ing to safety requirements.

ϘϘ When instructing new users, do so thor- oughly and explain the meanings of the warning signs and messages.

ϘϘ Assign individual responsibilities for start- ing, operating and servicing the instru- ment and monitor the observance of these responsibilities.

ϘϘ Do not use the Leica DM750 P microscope unless it is in perfect condition.

ϘϘ Inform your Leica representative or Leica Microsystems (Schweiz) AG, Industry Division, 9435 Heerbrugg, Switzerland, immediately of any product defect that could potentially cause injury or harm.

ϘϘ If you use accessories made by third-party manufacturers with the Leica DM750 P microscope, be sure that each such manu- facturer confirms the safety-engineering, harmless usability of the product and observe the product's user manual.

ϘϘ Modifications and maintenance of the Leica DM750 P microscope may only be performed by professionals expressly authorized by Leica.

ϘϘ Only original Leica replacement parts may be used in servicing the product.

ϘϘ After service work or technical modifica- tions, the unit must be reconfigured with observance to our technical requirements.

ϘϘ If the unit is modified or serviced by unau- thorized persons, is improperly maintained (as long as maintenance was not carried out by us), or is handled improperly, Leica will not accept any liability.

ϘϘ The electric installation in the building must conform to the national standard, e.g. current-operated ground leakage protec- tion (fault-current protection) is suggested.

Leica DM750 P	Manual	11

Image 11

Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Provide clarity Symbols used in this operating manualLight bulbs Important informationEC Declaration of Conformity Important NotesDescription Contact addressNon-intended use Instructions on useIntended use Place of useIntegration in third-party products To any warranty claimsTransport DisposalVidual or detachable eyecups Health risks and dangers of useHealth risks Viral infections of the eyeInformation for the person responsible for the instrument Information for the person responsible for the instrumentGeneral instructions Cleaning coated parts and plastic partsCleaning glass surfaces Care instructionsRepairs and service work Accessories, maintenance and repairAccessories MaintenanceEnvironment Fuse ReplacementElectrical data Input 100-240 V, 50/60 Hz, 5 W 3 W LEDLeica DM750 P Introduction Unpacking Check the components against the planned configurationGet Ready Tools used Attaching Analyzer Module or Analyzer/Bertrand Lens ModuleViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Work Surface Basic setupPower Objective Using the Aperture CondenserPolarizer Setting up Polarized LightSubstage condenser in a swing in/out Analyzer into position Focusing FocusingSlightly, if at all Viewing Tube AdjustmentSlot of the right eyetube Eyepiece. Do not raise or lower the stage to focusKoehler Set up Koehler Set upFocus the polarizing sample Objective CentrationϘϘ Centering keys Modules You can now view the conoscopic image through the eyepieces Bertrand Lens OperationImage through the eyepieces Or Disabled and you will not see any blinking Time Delay ShutoffChanging the status of the time delay shutoff Leica DM750 P Manual Ready! Set! Go Care of the Microscope This purpose For two compensators in the rear General maintenanceGeneral Hands. There is a handle on the back Is extendedAround the lens Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Should be moistened with solvent, butMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual