Leica dm750 p manual Basic setup, Work Surface, Power

Page 25

Basic setup

As a safety precaution, the power cord has been grounded to the microscope base. Never use an adapter between the power

cord and the power source; it will render the grounding feature ineffective.

Work Surface

•Always use your microscope on a hard, stable surface.

Power

1.If the power cord is not already attached, attach it securely to the back of the micro- scope.

2. Plug the

microscope

power cord into

a suitable

grounded

electrical outlet.

A grounded 3-wire cord is provided.

3.Set the illumination control (knob is located on the bottom left-hand side of the micro- scope stand) to the lowest setting to start. The illumination control knob allows you to adjust the intensity of light produced by the illumination system.

4.Turn on the microscope using the switch on the bottom right-hand side of the micro- scope stand.

Leica DM750 P

Manual

25

 

 

 

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Light bulbs Symbols used in this operating manualImportant information Provide clarityDescription Important NotesContact address EC Declaration of ConformityIntended use Instructions on usePlace of use Non-intended useTransport To any warranty claimsDisposal Integration in third-party productsHealth risks Health risks and dangers of useViral infections of the eye Vidual or detachable eyecupsInformation for the person responsible for the instrument Information for the person responsible for the instrumentCleaning glass surfaces Cleaning coated parts and plastic partsCare instructions General instructionsAccessories Accessories, maintenance and repairMaintenance Repairs and service workElectrical data Fuse ReplacementInput 100-240 V, 50/60 Hz, 5 W 3 W LED EnvironmentLeica DM750 P Introduction Unpacking Check the components against the planned configurationGet Ready Tools used Attaching Analyzer Module or Analyzer/Bertrand Lens ModuleViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Power Basic setupWork Surface Objective Using the Aperture CondenserSubstage condenser in a swing in/out Setting up Polarized LightPolarizer Analyzer into position Focusing FocusingSlot of the right eyetube Viewing Tube AdjustmentEyepiece. Do not raise or lower the stage to focus Slightly, if at allKoehler Set up Koehler Set upϘϘ Centering keys Objective CentrationFocus the polarizing sample Modules Image through the eyepieces Bertrand Lens OperationYou can now view the conoscopic image through the eyepieces Changing the status of the time delay shutoff Time Delay ShutoffOr Disabled and you will not see any blinking Leica DM750 P Manual Ready! Set! Go Care of the Microscope General General maintenanceHands. There is a handle on the back Is extended This purpose For two compensators in the rearϘϘ It is very important to avoid the excessive Lint-free cloth, lens tissue or cotton swabShould be moistened with solvent, but Around the lensMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual
Top Page Image Contents