Leica dm750 p manual Time Delay Shutoff, Changing the status of the time delay shutoff

Page 35

Time Delay Shutoff

The Leica DM 750 P is equipped with a time delay shutoff capability, which automatically turns the illumination off after 2

hours of no changes in the intensity control.

ϘϘ The time delay shutoff IS enabled as a default.

Changing the status of the time delay shutoff

1.Rotate the intensity control to the lowest setting.

2.Turn the power on.

3.Rotate the intensity control to full high intensity, then back to full low intensity all within 5 seconds.

ϘϘ The LED Illumination will flash to indicate the time delay shutoff status was changed.

ϘϘ The LED Illumination will flash two times slowly then stay on when you disable the Time Delay Shutoff.

ϘϘ The LED Illumination will flash three times quickly then stay on when you enable the Time Delay Shutoff.

When you turn the power off and then turn the power on again, the system will be in the last Time Delay Shutoff status (Enabled

or Disabled) and you will not see any blinking.

Leica DM750 P	Manual	35

Image 35

Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Provide clarity Symbols used in this operating manualLight bulbs Important informationEC Declaration of Conformity Important NotesDescription Contact addressNon-intended use Instructions on useIntended use Place of useIntegration in third-party products To any warranty claimsTransport DisposalVidual or detachable eyecups Health risks and dangers of useHealth risks Viral infections of the eyeInformation for the person responsible for the instrument Information for the person responsible for the instrumentGeneral instructions Cleaning coated parts and plastic partsCleaning glass surfaces Care instructionsRepairs and service work Accessories, maintenance and repairAccessories MaintenanceEnvironment Fuse ReplacementElectrical data Input 100-240 V, 50/60 Hz, 5 W 3 W LEDLeica DM750 P Introduction Unpacking Check the components against the planned configurationGet Ready Tools used Attaching Analyzer Module or Analyzer/Bertrand Lens ModuleViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Work Surface Basic setupPower Objective Using the Aperture CondenserPolarizer Setting up Polarized LightSubstage condenser in a swing in/out Analyzer into position Focusing FocusingSlightly, if at all Viewing Tube AdjustmentSlot of the right eyetube Eyepiece. Do not raise or lower the stage to focusKoehler Set up Koehler Set upFocus the polarizing sample Objective CentrationϘϘ Centering keys Modules You can now view the conoscopic image through the eyepieces Bertrand Lens OperationImage through the eyepieces Or Disabled and you will not see any blinking Time Delay ShutoffChanging the status of the time delay shutoff Leica DM750 P Manual Ready! Set! Go Care of the Microscope This purpose For two compensators in the rear General maintenanceGeneral Hands. There is a handle on the back Is extendedAround the lens Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Should be moistened with solvent, butMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual