Leica dm750 p manual Substage Condenser

Page 22

Substage Condenser

Substage Condenser

The Leica DM750 P has an open substage condenser mount. Therefore, the

condenser needs to be installed.

1.Raise the stage to its highest position using the coarse focus knob on the right side of the microscope.

2.Adjust the condenser mount to its lowest position using the condenser focus knob on the left-hand side of the substage.

3.Swing the polarizer, which is connected to the bottom of the condenser mount, to the left.

Leica DM750 P	Manual	22

Image 22

Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Important information Symbols used in this operating manualLight bulbs Provide clarityContact address Important NotesDescription EC Declaration of ConformityPlace of use Instructions on useIntended use Non-intended useDisposal To any warranty claimsTransport Integration in third-party productsViral infections of the eye Health risks and dangers of useHealth risks Vidual or detachable eyecupsInformation for the person responsible for the instrument Information for the person responsible for the instrumentCare instructions Cleaning coated parts and plastic partsCleaning glass surfaces General instructionsMaintenance Accessories, maintenance and repairAccessories Repairs and service workInput 100-240 V, 50/60 Hz, 5 W 3 W LED Fuse ReplacementElectrical data EnvironmentLeica DM750 P Introduction Check the components against the planned configuration UnpackingGet Ready Attaching Analyzer Module or Analyzer/Bertrand Lens Module Tools usedViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Power Basic setupWork Surface Using the Aperture Condenser ObjectiveSubstage condenser in a swing in/out Setting up Polarized LightPolarizer Analyzer into position Focusing FocusingEyepiece. Do not raise or lower the stage to focus Viewing Tube AdjustmentSlot of the right eyetube Slightly, if at allKoehler Set up Koehler Set upϘϘ Centering keys Objective CentrationFocus the polarizing sample Modules Image through the eyepieces Bertrand Lens OperationYou can now view the conoscopic image through the eyepieces Changing the status of the time delay shutoff Time Delay ShutoffOr Disabled and you will not see any blinking Leica DM750 P Manual Ready! Set! Go Care of the Microscope Hands. There is a handle on the back Is extended General maintenanceGeneral This purpose For two compensators in the rearShould be moistened with solvent, but Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Around the lensMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual