Leica dm750 p manual Completely loosen the two thumbscrews on the condenser mount

Page 23

Substage Condenser (cont.)

4.Completely loosen the two thumbscrews on the condenser mount.

5.Slide the substage condenser into the fork mount located underneath the stage by aligning the positioning pin on the condenser into the slot on the back of the fork.

6.Raise the condenser to its highest position using the condenser focus on the left-hand side of the substage

7.Tighten the thumbscrews to roughly center the substage condenser so that the top lens of the condenser is centered beneath the objective in use. You will more accurately center and focus the condenser when you reach section Koehler Setup.

Leica DM750 P	Manual	23

Image 23

Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Provide clarity Symbols used in this operating manualLight bulbs Important informationEC Declaration of Conformity Important NotesDescription Contact addressNon-intended use Instructions on useIntended use Place of useIntegration in third-party products To any warranty claimsTransport DisposalVidual or detachable eyecups Health risks and dangers of useHealth risks Viral infections of the eyeInformation for the person responsible for the instrument Information for the person responsible for the instrumentGeneral instructions Cleaning coated parts and plastic partsCleaning glass surfaces Care instructionsRepairs and service work Accessories, maintenance and repairAccessories MaintenanceEnvironment Fuse ReplacementElectrical data Input 100-240 V, 50/60 Hz, 5 W 3 W LEDLeica DM750 P Introduction Unpacking Check the components against the planned configurationGet Ready Tools used Attaching Analyzer Module or Analyzer/Bertrand Lens ModuleViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Work Surface Basic setupPower Objective Using the Aperture CondenserPolarizer Setting up Polarized LightSubstage condenser in a swing in/out Analyzer into position Focusing FocusingSlightly, if at all Viewing Tube AdjustmentSlot of the right eyetube Eyepiece. Do not raise or lower the stage to focusKoehler Set up Koehler Set upFocus the polarizing sample Objective CentrationϘϘ Centering keys Modules You can now view the conoscopic image through the eyepieces Bertrand Lens OperationImage through the eyepieces Or Disabled and you will not see any blinking Time Delay ShutoffChanging the status of the time delay shutoff Leica DM750 P Manual Ready! Set! Go Care of the Microscope This purpose For two compensators in the rear General maintenanceGeneral Hands. There is a handle on the back Is extendedAround the lens Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Should be moistened with solvent, butMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual