Leica dm750 p Symbols used in this operating manual, Light bulbs, Important information

Page 6

Symbols used in this operating manual

Warning of a danger

•This symbol indicates especially impor- tant information that must be read and

complied with.

Failure to comply can cause the following: ϘϘ Hazards to personnel

ϘϘ Functional disturbances or damaged instru- ments

Warning of hazardous electrical voltage This symbol indicates especially impor- tant information that is mandatory to

read and observe.

Failure to comply can cause the following: ϘϘ Hazards to personnel

ϘϘ Functional disturbances or damaged instruments

Danger due to hot surface.

This symbol warns against touching accessible hot surfaces, e.g. those of

light bulbs.

Important information

This symbol indicates additional infor- mation or explanations that intend to

provide clarity.

Explanatory notes

▶▶ This symbol within the text points to addi- tional information and explanations.

Leica DM750 P	Manual	6

Image 6

Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Important information Symbols used in this operating manualLight bulbs Provide clarityContact address Important NotesDescription EC Declaration of ConformityPlace of use Instructions on useIntended use Non-intended useDisposal To any warranty claimsTransport Integration in third-party productsViral infections of the eye Health risks and dangers of useHealth risks Vidual or detachable eyecupsInformation for the person responsible for the instrument Information for the person responsible for the instrumentCare instructions Cleaning coated parts and plastic partsCleaning glass surfaces General instructionsMaintenance Accessories, maintenance and repairAccessories Repairs and service workInput 100-240 V, 50/60 Hz, 5 W 3 W LED Fuse ReplacementElectrical data EnvironmentLeica DM750 P Introduction Check the components against the planned configuration UnpackingGet Ready Attaching Analyzer Module or Analyzer/Bertrand Lens Module Tools usedViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Basic setup PowerWork Surface Using the Aperture Condenser ObjectiveSetting up Polarized Light Substage condenser in a swing in/outPolarizer Analyzer into position Focusing FocusingEyepiece. Do not raise or lower the stage to focus Viewing Tube AdjustmentSlot of the right eyetube Slightly, if at allKoehler Set up Koehler Set upObjective Centration ϘϘ Centering keysFocus the polarizing sample Modules Bertrand Lens Operation Image through the eyepiecesYou can now view the conoscopic image through the eyepieces Time Delay Shutoff Changing the status of the time delay shutoffOr Disabled and you will not see any blinking Leica DM750 P Manual Ready! Set! Go Care of the Microscope Hands. There is a handle on the back Is extended General maintenanceGeneral This purpose For two compensators in the rearShould be moistened with solvent, but Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Around the lensMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual