Leica dm750 p Care instructions, General instructions, Cleaning coated parts and plastic parts

Page 12

Care instructions

General instructions

ϘϘ Protect the Leica DM750 P microscope against damp, vapors, acids, alkalis, and corrosive substances. Do not store chemi- cals in the vicinity.

ϘϘ Protect the Leica DM750 P microscope from oil and grease. Never grease or oil mechani- cal parts or sliding surfaces.

ϘϘ Follow the instructions of the disinfectant manufacturer.

ϘϘ It is advisable to enter a service agreement with Leica Service.

Cleaning coated parts and plastic parts

ϘϘ Dust and dirt particles should be removed with a soft brush or lint-free cotton cloth.

ϘϘ Remove coarse debris with a moistened disposable cloth.

ϘϘ Clinging dirt can be removed using petro- leum ether or alcohol

ϘϘ Acetone, xylene or nitro-containing thin- ners must NOT be used.

ϘϘ Never use chemicals to clean colored surfaces or accessories with rubberized parts. This could damage the surfaces, and specimens could be contaminated by abraded particles.

Cleaning glass surfaces

ϘϘ Remove dust using a fine, dry and grease- free brush made from hair, by blowing with a squeeze blower, or by using a vacuum.

ϘϘ Remove dirt using a clean cloth that has been moistened with distilled water.

ϘϘ Remove tough dirt using alcohol, chloro- form or petroleum ether.

Leica DM750 P	Manual	12

Image 12

Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Symbols used in this operating manual Light bulbsImportant information Provide clarityImportant Notes DescriptionContact address EC Declaration of ConformityInstructions on use Intended usePlace of use Non-intended useTo any warranty claims TransportDisposal Integration in third-party productsHealth risks and dangers of use Health risksViral infections of the eye Vidual or detachable eyecupsInformation for the person responsible for the instrument Information for the person responsible for the instrumentCleaning coated parts and plastic parts Cleaning glass surfacesCare instructions General instructionsAccessories, maintenance and repair AccessoriesMaintenance Repairs and service workFuse Replacement Electrical dataInput 100-240 V, 50/60 Hz, 5 W 3 W LED EnvironmentLeica DM750 P Introduction Check the components against the planned configuration UnpackingGet Ready Attaching Analyzer Module or Analyzer/Bertrand Lens Module Tools usedViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Basic setup PowerWork Surface Using the Aperture Condenser ObjectiveSetting up Polarized Light Substage condenser in a swing in/outPolarizer Analyzer into position Focusing FocusingViewing Tube Adjustment Slot of the right eyetubeEyepiece. Do not raise or lower the stage to focus Slightly, if at allKoehler Set up Koehler Set upObjective Centration ϘϘ Centering keysFocus the polarizing sample Modules Bertrand Lens Operation Image through the eyepiecesYou can now view the conoscopic image through the eyepieces Time Delay Shutoff Changing the status of the time delay shutoffOr Disabled and you will not see any blinking Leica DM750 P Manual Ready! Set! Go Care of the Microscope General maintenance GeneralHands. There is a handle on the back Is extended This purpose For two compensators in the rearLint-free cloth, lens tissue or cotton swab ϘϘ It is very important to avoid the excessiveShould be moistened with solvent, but Around the lensMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual