Leica dm750 p manual Contents

Page 3

Safety regulations	4
Safety concept	5
Symbols used in this operating manual	6
Important Notes	7
Instructions on use	8
Health risks and dangers of use	10
Information for the person responsible
for the instrument	11
Care instructions	12
Accessories, maintenance and repair	13
Electrical data and ambient conditions	14

The Leica DM750 P	15
Introduction	16
Unpacking	17

Get Ready!	18
Attaching Analyzer Module or Analyzer/
Bertrand Lens Module	19
Viewing Tube	20
Installing Objectives	21
Substage Condenser	22

Get Set!	24
Basic setup	25
Using the Aperture Condenser	26
Setting up Polarized Light	27
Focusing	29
Viewing Tube Adjustment	30
Koehler Set up	31
Objective Centration	32
Bertrand Lens Operation	34
Time Delay Shutoff	35

Go!	36
Ready! Set! Go!	37

Care of the Microscope	38
General maintenance	39
Mechanical Maintenance	41

Dimensions	42

Leica DM750 P	Manual	3

Image 3

Contents Leica DM750 P Manual Chapter overview Contents Safety regulations Safety concept Provide clarity Symbols used in this operating manualLight bulbs Important informationEC Declaration of Conformity Important NotesDescription Contact addressNon-intended use Instructions on useIntended use Place of useIntegration in third-party products To any warranty claimsTransport DisposalVidual or detachable eyecups Health risks and dangers of useHealth risks Viral infections of the eyeInformation for the person responsible for the instrument Information for the person responsible for the instrumentGeneral instructions Cleaning coated parts and plastic partsCleaning glass surfaces Care instructionsRepairs and service work Accessories, maintenance and repairAccessories MaintenanceEnvironment Fuse ReplacementElectrical data Input 100-240 V, 50/60 Hz, 5 W 3 W LEDLeica DM750 P Introduction Unpacking Check the components against the planned configurationGet Ready Tools used Attaching Analyzer Module or Analyzer/Bertrand Lens ModuleViewing Tube Installing Objectives Substage Condenser Substage CondenserCompletely loosen the two thumbscrews on the condenser mount Get Set Basic setup PowerWork Surface Objective Using the Aperture CondenserSetting up Polarized Light Substage condenser in a swing in/outPolarizer Analyzer into position Focusing FocusingSlightly, if at all Viewing Tube AdjustmentSlot of the right eyetube Eyepiece. Do not raise or lower the stage to focusKoehler Set up Koehler Set upObjective Centration ϘϘ Centering keysFocus the polarizing sample Modules Bertrand Lens Operation Image through the eyepiecesYou can now view the conoscopic image through the eyepieces Time Delay Shutoff Changing the status of the time delay shutoffOr Disabled and you will not see any blinking Leica DM750 P Manual Ready! Set! Go Care of the Microscope This purpose For two compensators in the rear General maintenanceGeneral Hands. There is a handle on the back Is extendedAround the lens Lint-free cloth, lens tissue or cotton swabϘϘ It is very important to avoid the excessive Should be moistened with solvent, butMechanical Maintenance Mechanical MaintenanceDimensions Leica DM750 P Manual Leica DM750 P Manual Leica DM750 P Manual