AT&T CL84350 Adding and registering handsets, To register a handset to your telephone base

Appendix

Adding and registering handsets

When first purchased, all expansion handsets alternately show 1.Press HS LOC on base 4sec and

2.Then press # on handset on the screen. The new handset should be charged without interruption for

at least 30 minutes before registering it to the telephone base.

To register a handset to your telephone base

1.	Make sure the handset is out of the charger and
	alternately shows 1.Press HS LOC on base 4sec	1.Press HS LOC
	and 2.Then press # on handset before you begin	on base 4sec
	registration.
2.	Press and hold LOCATOR on the telephone base
	for about four seconds until the base screen shows	2.Then press #
	Registering handset..., then release the button.
		on handset

3.Press # (pound key) on the handset. The screen shows Registering... Please wait. It takes up to 60 seconds to complete registration. Then HANDSET X Registered appears on the screen, with X being the handset number (1-12), and the handset beeps. The handset is now registered with the telephone base.

If registration is not successful, the handset screen displays Registration failed. Please start again from step one above.

NOTES:

1.You cannot register a handset if any other system handset is in use.

2.You cannot register more than 12 handsets to the telephone base. Registration slots are full shows on the base screen while you are doing step two above.

Registering

handset...

Registering...

Please wait

HANDSET X

Registered

HANDSET X

Registered

69