AT&T 9370 user manual Changing Channels, Headset Jack

Page 24

9370_to make pdf_1ATT 6/12/00 2:07 PM Page 22

TELEPHONE OPERATION

AT THE HANDSET

Changing Channels

This cordless telephone has an advanced AutoSelect feature that minimizes the chance of interference. When the phone is looking for a clear channel, the screen displays SEARCHING.... If it is unable to locate a clear channel, the screen displays TRY AGAIN. Hang up and try your call again.

In the unlikely event that you notice noise or interference while using the handset:

1Press L.

2If the interference does not clear, move closer to the base and press Lagain until you find a clear channel (your call will not be interrupted).

NOTE: You must be in range of the base to change channels (see the OPERATING RANGE section of this manual).

Headset Jack

You can use this telephone hands-free when you install an AT&T 2.5 mm headset (purchased separately).

1Plug the headset into the jack located on the left side of the handset. Do not force the connection, but make sure the plug fits securely.

2Follow the instructions under “Make,Answer, or End a Call” on page 19.

3If you wish, attach the belt clip (see page 5 in the INSTALLATION section of this manual).

NOTE: The earpiece and microphone on the handset are disabled when the headset is plugged in.

22

Image 24

Contents Revised 6/12/00 Advanced American Telephones. All rights reserved Contents Page Before YOU Begin About Caller ID with Call WaitingAbout Home and Local Area Codes Installation Before You InstallTable/Desk and Wall Installation Install the handset batteryConnect the telephone line cord Feature Setup Message Window Display for Feature SetupSoftkeys Telephone Feature Setup Dial ModeHandset Ringer Off / Battery Save Handset RingerCaller ID Feature Setup Program Home and Local Area CodesCaller ID with Call Waiting Call List OptionsAnswering System Feature Setup Select Your Announcement Ring Select / Toll SaverAudible Message Alert Change Remote Access Code Priority Call SignalChange Priority Calling Code Review Feature Settings Record Your Announcement from the BaseDelete an Announcement Set the ClockCaller Specific Outgoing Announcement Feature Setup Talking Caller ID Feature SetupAnnouncements Outgoing Local Review ADD Enter Number Done Menu Call ID DIR Directory MEM ANS SYS Delete Done Telephone Operation Redial Temporary ToneMute Hold IntercomRecord a Phone Conversation Changing Channels Headset JackSpeaker Base Ringer Volume AT the BasePage/Intercom Handset LocatorTelephone MEMORY/DIRECTORY Store a Number in MemoryStore a Pause in a Memory Number Store a Name with a Memory NumberReplace a Stored Number Store a Number and Name from Call History View Memory NumbersDelete Memory Numbers Edit Memory NumbersPriority Ring Numbers Dial a Memory Number from the HandsetDial a Memory Number from the Base Audible Indicators Answering System OperationAbout Mailboxes Announcement Play/SilentAnswering Calls Call Screening/InterceptAnnouncement Bypass Record a MemoListen To, Save & Delete Messages Function ButtonMessage Window Display CL ↔ AOCall Screening Connect with the Answering SystemFrom the Cordless Handset From a Touch Tone PhoneRemote Access Commands Function CommandEnd remote access call Audible Signals Voice Help MenuCall Waiting Incoming Call HistoryMemory Match Caller ID Operation Review Call HistoryDisplay Dial Delete Call Records from Call History Delete a Specific Call RecordCaller ID Display Messages Delete All Call RecordsOperating Range Battery Life Charge the Handset Battery PackBatteries Batteries Replace the Handset Battery Pack Case of Difficulty If the phone does not work at all, check these items firstIf you have no dial tone To re-initialize the handset and baseIf you hear noise or interference when using the phone If the phone does not ring when you receive a callIf the caller’s name or phone number is not displayed If speakerphone conversation sounds distorted If messages are incompleteIf you have difficulty hearing messages If CL appears in the Message Window If your outgoing announcement isn’t clearIndex Index Remote Commands Answering SystemRemote Command Press