BEFORE YOU BEGIN
Parts List
Your box should include:
USER’S MANUAL
Part 2
2.4GHz Cordless Telephone Answering System 2325/2365
with Caller ID/Call Waiting
Please also read
Part 1 — Important
Product Information
© 2002 Advanced American Telephones. All rights reserved.
AT&T and the Globe Design are trademarks of AT&T Corp. licensed to Advanced American Telephones.
This User’s Manual
INSTALLATION
Table/Desk Installation
NOTE: Install this telephone away from electronic equipment, such as personal computers, television
sets or microwave ovens. Avoid excessive heat, cold, dust or moisture.
1Connect the telephone line cord. (figure a)
2Connect the power cord to the base and an electrical outlet not controlled by a wall switch. (figure a) The ANSWER ON/OFF light goes on, and CL flashes in the message window.
Use only the power cord supplied with this product.
If you need a replacement, call 1 800
3Install the handset battery. Use only AT&T Battery 3301, SKU# 91076. (figure b)
4Charge the handset battery.
•Place the handset in the base.
•Charge the battery at least 12 hours. After the first charge, the battery will charge in eight hours.
5Check for dial tone.
•After the batteries are charged, lift the handset and press P; you should hear a dial tone.
For detailed instructions for wall installation, to remove the belt clip, or use a headset with this phone please refer to the INSTALLATION section of your User’s Manual.
NOTE: If you have purchased the AT&T 2365, you must place the fully charged 2300 Expansion Headset into your 2365 base for registration. Refer to your 2300 User’s Manual for more etials.
QUICK START GUIDE
2.4GHz Cordless Telephone 2325/2365 with Caller ID/Call Waiting
Modular | Standard |
telephone | electrical |
jack | outlet |
Line Cord | Power Cord |
figure a
a) Remove battery | b) Plug the battery pack |
compartment cover by | connector into handset. |
pressing on indentation | Place the battery pack and |
and sliding downward. | wires in the compartment. |
c) Replace cover by sliding it on its track up over battery case until it snaps firmly into place.
figure b
Quick
Start
Guide
Base Unit
Wallet Card
Answering System 2325/2365
Remote Commands
To connect with your answering system:
1Dial your telephone number from a touch tone phone.
2When the system answers enter your Remote Access Code (preset to 50).
3Within 10 seconds, enter a remote command from inside this card.
Handset
YOU |
BEFORE |
NiCd
Powerbattery pack adapter
2 Telephone line cord
NOTE: If you have purchased the AT&T 2365, please also refer to the parts list in your AT&T 2300 User’s Manual.
1