NEC SP5008A user manual Network Configuration

Page 10

2.2 Network Configuration

By default, the gateway is in NAT mode (router mode) and can share Internet access with PCs. Go to [ Network Configuration / WAN Setting ], and configure WAN setting according to actual condition. In default IP type of DHCP client, it requests necessary IP information from your ISP automatically.

-----------------------------------------------------------------------------------------------------

Note:

1.Different ISPs require different methods of connecting to the Internet. Please consult your ISP to select right IP type (Fixed IP, PPPoE) of WAN.

2.You can retrieve the IP address of the WAN port by keying #126# on the phone set that is connected to the FXS port of the gateway. You will hear an IVR announcing the current IP address of the WAN port.

-----------------------------------------------------------------------------------------------------

9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents IP Telephony Gateway Online Upgrade Introduction Table of ContentWeb Administration StartupSpecification OperationKey Features IntroductionSP5058A LED IndicatorsPhysical Description SP5018AL1-L8 SP5008AT1-T8 T1/P1-T4/P4Login into the System StartupPage Network Configuration WAN Setting DhcpEnable/Disable this option Static IPDhcp PPPoE LAN Setting DescriptionDescription SIP Setting General configurationPabx Mode SP5018A only Pabx ConnectionPrimary FXS SIP settings FXO Dialing PrefixSIP Setting Number PasswordAccount Display nameSIP Advanced Setting It and you enable this feature, all IP outgoing calls Make sure your proxy server or soft switchSupports the feature, if the proxy does not support Feature is for FXS onlyPayload Type Setting Page Line Setting Line1~Line8 relevant data Type Enable HotlineNo Answer Forward Time FXS only RegPage Dscp Signal Qos SettingDifferentiated Services Code Point Setting Dscp ToS Setting ToS RTPSpeed Dial Speed Dial SettingSpeed Dial Editor Peer to Peer call Speed Dial Editor In P2P applicationDtmf Caller ID Start Symbol Caller ID SettingCaller ID Setting Line 1~Line Dtmf Caller ID End SymbolDefault symbol is C CDR Setting CDR mode CDR Server address CDR Server portPage Syslog Setting Syslog mode Syslog Server address Syslog Server portPage Advanced Configuration System settingPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Packet Size Codec SettingCodec Priority Bandwidth RequiredVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Min. Digit Count CountryDigit Manipulation FXO Dial Prefix Dial Plan Editor Dial PlanThird Example Page Management Provision ServerSave-Reload setting Export File Import FileUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Network Status Displays the MAC address of the WAN portPost version Boot versionVersion Info Application versionPort Type Port StatusRegister Proxy New password PasswordCurrent password Confirm new passwordRebooting the system Configuration Peer to Peer mode FXO to FXSEnable the representative line All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking
Top Page Image Contents