NEC SP5008A user manual Syslog Setting, Syslog mode Syslog Server address Syslog Server port

Page 35

3.1.8 Syslog Setting

This syslog is used to send the debug log from MICRONET SP5008A / SP5018A / SP5058A to syslog server.

Syslog mode

Syslog Server address

Syslog Server port

Select the Syslog mode for Enable or Disable. If you Enable this feature, please specify the Syslog Server address and port number at the Syslog server address and port’s text box, then you can get detail system log from Syslog server. If you Enable the Syslog mode, please specify the IP address of Syslog Sever for data storage. Specify the Syslog Server port number,

The default port number is 514.

1.Press the “Apply” button (at the bottom) after you finish to save changes.

2.Press the “Reboot” button to apply the changes.

NOTE: To receive the SYSLOG debug information, you need to have a syslogd server to collect the debug information from MICRONET SP5008A / SP5018A / SP5058A . The following is a tool you can be used for testing purpose which can be downloaded from http://tftpd32.jounin.net/. You need to enable syslog server from settings before you can use it.

34

Image 35

Contents IP Telephony Gateway Online Upgrade Startup Table of ContentWeb Administration IntroductionOperation SpecificationIntroduction Key FeaturesSP5018A LED IndicatorsPhysical Description SP5058AT1/P1-T4/P4 SP5008AT1-T8 L1-L8Startup Login into the SystemPage Network Configuration Dhcp WAN SettingStatic IP Enable/Disable this optionDhcp PPPoE Description LAN SettingDescription Pabx Connection General configurationPabx Mode SP5018A only SIP SettingFXO Dialing Prefix Primary FXS SIP settingsSIP Setting Display name PasswordAccount NumberSIP Advanced Setting Feature is for FXS only Make sure your proxy server or soft switchSupports the feature, if the proxy does not support It and you enable this feature, all IP outgoing callsPayload Type Setting Page Line Setting Reg Enable HotlineNo Answer Forward Time FXS only Line1~Line8 relevant data TypePage ToS Setting ToS RTP Qos SettingDifferentiated Services Code Point Setting Dscp Dscp SignalSpeed Dial Editor Speed Dial SettingSpeed Dial Speed Dial Editor In P2P application Peer to Peer callDtmf Caller ID End Symbol Caller ID SettingCaller ID Setting Line 1~Line Dtmf Caller ID Start SymbolDefault symbol is C CDR mode CDR Server address CDR Server port CDR SettingPage Syslog mode Syslog Server address Syslog Server port Syslog SettingPage System setting Advanced ConfigurationPage Page Ping ip to keep alive network Ping timersec Sntp Setting Bandwidth Required Codec SettingCodec Priority Codec Packet SizeVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Country Min. Digit CountDigit Manipulation FXO Dial Prefix Third Example Dial PlanDial Plan Editor Page Provision Server ManagementExport File Import File Save-Reload settingUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Displays the MAC address of the WAN port Network StatusApplication version Boot versionVersion Info Post versionRegister Proxy Port StatusPort Type Confirm new password PasswordCurrent password New passwordRebooting the system Enable the representative line Peer to Peer mode FXO to FXSConfiguration All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking