NEC SP5008A user manual Description

Page 16

ITEM	Description
Domain Name	You can specify the domain name that will be
	assigned by the DHCP server to the attached
	network devices. The DHCP server will send
	information on the “server host name” to the
	DHCP client.

Lease time(sec)	You can specify the maximum lease time of the
	IP address allocated to the DHCP client.

DNS server mode	Select the DNS behavior, you can choose the
	following:
	z	Auto
	z	Manual
	“DNS auto” will retrieve the DNS information sent
	from the DHCP server.
	“Manual” will look at the specified Primary and
	Secondary DNS address.

Primary DNS address	Specify the address of the Primary DNS.

Secondary DNS address	Specify the address of the Secondary DNS.

1.Press the “Apply” button (at the bottom) after you finish to save changes.

2.Press the “Reboot” button to apply the changes.

15

Image 16

Contents IP Telephony Gateway Online Upgrade Table of Content Web AdministrationIntroduction StartupSpecification OperationKey Features IntroductionLED Indicators Physical DescriptionSP5058A SP5018ASP5008A T1-T8L1-L8 T1/P1-T4/P4Login into the System StartupPage Network Configuration WAN Setting DhcpEnable/Disable this option Static IPDhcp PPPoE LAN Setting DescriptionDescription General configuration Pabx Mode SP5018A onlySIP Setting Pabx ConnectionPrimary FXS SIP settings FXO Dialing PrefixSIP Setting Password AccountNumber Display nameSIP Advanced Setting Make sure your proxy server or soft switch Supports the feature, if the proxy does not supportIt and you enable this feature, all IP outgoing calls Feature is for FXS onlyPayload Type Setting Page Line Setting Enable Hotline No Answer Forward Time FXS onlyLine1~Line8 relevant data Type RegPage Qos Setting Differentiated Services Code Point Setting DscpDscp Signal ToS Setting ToS RTPSpeed Dial Speed Dial SettingSpeed Dial Editor Peer to Peer call Speed Dial Editor In P2P applicationCaller ID Setting Caller ID Setting Line 1~LineDtmf Caller ID Start Symbol Dtmf Caller ID End SymbolDefault symbol is C CDR Setting CDR mode CDR Server address CDR Server portPage Syslog Setting Syslog mode Syslog Server address Syslog Server portPage Advanced Configuration System settingPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Setting Codec PriorityCodec Packet Size Bandwidth RequiredVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Min. Digit Count CountryDigit Manipulation FXO Dial Prefix Dial Plan Editor Dial PlanThird Example Page Management Provision ServerSave-Reload setting Export File Import FileUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Network Status Displays the MAC address of the WAN portBoot version Version InfoPost version Application versionPort Type Port StatusRegister Proxy Password Current passwordNew password Confirm new passwordRebooting the system Configuration Peer to Peer mode FXO to FXSEnable the representative line All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking