NEC SP5008A user manual Management, Provision Server

Page 53

3.3 Management

3.3.1 Provision Server

Note: If you need this requirement, Please contact MICRONET for availabilities.

Provision server Mode	Enable/Disable provision function

Provision server IP address	Specify the Provision Server’s IP address.

Provision server port	Specify the Provision server port

Provision cycle time	Specify the cycle time of the provisioning.(unit: sec)

Provision default time	Specify a scheduled time in a day

1.Press the “Apply” button (at the bottom) after you finish to save changes.

2.Press the “Reboot” button to apply the changes.

52

Image 53

Contents IP Telephony Gateway Online Upgrade Web Administration Table of ContentIntroduction StartupOperation SpecificationIntroduction Key FeaturesPhysical Description LED IndicatorsSP5058A SP5018AT1-T8 SP5008AL1-L8 T1/P1-T4/P4Startup Login into the SystemPage Network Configuration Dhcp WAN SettingStatic IP Enable/Disable this optionDhcp PPPoE Description LAN SettingDescription Pabx Mode SP5018A only General configurationSIP Setting Pabx ConnectionFXO Dialing Prefix Primary FXS SIP settingsSIP Setting Account PasswordNumber Display nameSIP Advanced Setting Supports the feature, if the proxy does not support Make sure your proxy server or soft switchIt and you enable this feature, all IP outgoing calls Feature is for FXS onlyPayload Type Setting Page Line Setting No Answer Forward Time FXS only Enable HotlineLine1~Line8 relevant data Type RegPage Differentiated Services Code Point Setting Dscp Qos SettingDscp Signal ToS Setting ToS RTPSpeed Dial Editor Speed Dial SettingSpeed Dial Speed Dial Editor In P2P application Peer to Peer callCaller ID Setting Line 1~Line Caller ID SettingDtmf Caller ID Start Symbol Dtmf Caller ID End SymbolDefault symbol is C CDR mode CDR Server address CDR Server port CDR SettingPage Syslog mode Syslog Server address Syslog Server port Syslog SettingPage System setting Advanced ConfigurationPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Priority Codec SettingCodec Packet Size Bandwidth RequiredVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Country Min. Digit CountDigit Manipulation FXO Dial Prefix Third Example Dial PlanDial Plan Editor Page Provision Server ManagementExport File Import File Save-Reload settingUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Displays the MAC address of the WAN port Network StatusVersion Info Boot versionPost version Application versionRegister Proxy Port StatusPort Type Current password PasswordNew password Confirm new passwordRebooting the system Enable the representative line Peer to Peer mode FXO to FXSConfiguration All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking