NEC SP5008A user manual Min. Digit Count, Country

Page 48

Ringing Frequency	Specify the Ringing frequency value.
	ringing frequency : 15~100 (Unit : Hz)

Ringing ON	Specify the Ringing ON value.
	ringing ring ON : 0~8000 (Unit : ms)

Ringing OFF	Specify the Ringing OFF value.
	ringing ring OFF : 0~8000 (Unit : ms)

Ringing level	Specify the ringing level.
	ringing level : 0 ~ 94	(Unit : V)

Min. Digit Count	Specify the minimum digit count (1~10, 0: Disable), this
	feature is used to change the ringing frequency by detecting
	the digit length of incoming calls’ number. When the digit
	length of an incoming caller number is greater than the
	specified setting, the system will use primary ringing. If the
	digit is less than the specified setting, the system will use the
	secondary ringing.

Country	Specify the ringing standard to use.

1.Press the “Apply” button (at the bottom) after you finish to save changes.

2.Press the “Reboot” button to apply the changes.

47

Image 48

Contents IP Telephony Gateway Online Upgrade Table of Content Web AdministrationIntroduction StartupSpecification OperationKey Features IntroductionLED Indicators Physical DescriptionSP5058A SP5018ASP5008A T1-T8L1-L8 T1/P1-T4/P4Login into the System StartupPage Network Configuration WAN Setting DhcpEnable/Disable this option Static IPDhcp PPPoE LAN Setting DescriptionDescription General configuration Pabx Mode SP5018A onlySIP Setting Pabx ConnectionPrimary FXS SIP settings FXO Dialing PrefixSIP Setting Password AccountNumber Display nameSIP Advanced Setting Make sure your proxy server or soft switch Supports the feature, if the proxy does not supportIt and you enable this feature, all IP outgoing calls Feature is for FXS onlyPayload Type Setting Page Line Setting Enable Hotline No Answer Forward Time FXS onlyLine1~Line8 relevant data Type RegPage Qos Setting Differentiated Services Code Point Setting DscpDscp Signal ToS Setting ToS RTPSpeed Dial Setting Speed DialSpeed Dial Editor Peer to Peer call Speed Dial Editor In P2P applicationCaller ID Setting Caller ID Setting Line 1~LineDtmf Caller ID Start Symbol Dtmf Caller ID End SymbolDefault symbol is C CDR Setting CDR mode CDR Server address CDR Server portPage Syslog Setting Syslog mode Syslog Server address Syslog Server portPage Advanced Configuration System settingPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Setting Codec PriorityCodec Packet Size Bandwidth RequiredVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Min. Digit Count CountryDigit Manipulation FXO Dial Prefix Dial Plan Dial Plan EditorThird Example Page Management Provision ServerSave-Reload setting Export File Import FileUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Network Status Displays the MAC address of the WAN portBoot version Version InfoPost version Application versionPort Status Port TypeRegister Proxy Password Current passwordNew password Confirm new passwordRebooting the system Peer to Peer mode FXO to FXS ConfigurationEnable the representative line All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking