NEC SP5008A Account, Password, Display name, Forward Number, Ring Type, Status, Priority

Page 20

	Register or Unregister to SIP Proxy

Account	Input the SIP Proxy registration account ID.

Number	Input the phone number.

Password	Input the password of IP Proxy registration account ID.

Display name	Specify the Display name of the phone number

Forward	Specify the Representative forwarding type to be used, only
	choose busy

Forward Number	Specify the number to be forwarded when the specified
	forward condition is met.

Ring Type	Select the Ring Type of representative number. You can
	choose the following:
	z Serial ring (Follow the ring priority defined
	below)
	z Simultaneous(ring all)

Ring Time (s) for Serial ring	Specify the Ring Time for Serial ring

Status	Displays the registration status, whether it is registered or not.

Priority	Select the group of representative number, and specify the
	priority.
	Only the checked line will become the member of the
	representative number.
	The default setting L1~L8 is grouped.

1.Enter the IP address and port number of the SIP proxy into the Primary proxy address and Port fields. Press the “Apply” button to save changes.

2.Press the “Reboot” button to apply the changes.

19

Image 20

Contents IP Telephony Gateway Online Upgrade Table of Content Web AdministrationIntroduction StartupSpecification OperationKey Features IntroductionLED Indicators Physical DescriptionSP5058A SP5018ASP5008A T1-T8L1-L8 T1/P1-T4/P4Login into the System StartupPage Network Configuration WAN Setting DhcpEnable/Disable this option Static IPDhcp PPPoE LAN Setting DescriptionDescription General configuration Pabx Mode SP5018A onlySIP Setting Pabx ConnectionPrimary FXS SIP settings FXO Dialing PrefixSIP Setting Password AccountNumber Display nameSIP Advanced Setting Make sure your proxy server or soft switch Supports the feature, if the proxy does not supportIt and you enable this feature, all IP outgoing calls Feature is for FXS onlyPayload Type Setting Page Line Setting Enable Hotline No Answer Forward Time FXS onlyLine1~Line8 relevant data Type RegPage Qos Setting Differentiated Services Code Point Setting DscpDscp Signal ToS Setting ToS RTPSpeed Dial Editor Speed Dial SettingSpeed Dial Peer to Peer call Speed Dial Editor In P2P applicationCaller ID Setting Caller ID Setting Line 1~LineDtmf Caller ID Start Symbol Dtmf Caller ID End SymbolDefault symbol is C CDR Setting CDR mode CDR Server address CDR Server portPage Syslog Setting Syslog mode Syslog Server address Syslog Server portPage Advanced Configuration System settingPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Setting Codec PriorityCodec Packet Size Bandwidth RequiredVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Min. Digit Count CountryDigit Manipulation FXO Dial Prefix Third Example Dial PlanDial Plan Editor Page Management Provision ServerSave-Reload setting Export File Import FileUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Network Status Displays the MAC address of the WAN portBoot version Version InfoPost version Application versionRegister Proxy Port StatusPort Type Password Current passwordNew password Confirm new passwordRebooting the system Enable the representative line Peer to Peer mode FXO to FXSConfiguration All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking