NEC SP5008A Qos Setting, Differentiated Services Code Point Setting Dscp, Dscp Signal, ToS Signal

Page 28

3.1.4 Qos Setting

Type	Select Qos Type: DSCP or ToS

Differentiated Services Code Point Setting (DSCP)

DSCP RTP	Select the DSCP value for RTP (voice packets), the
	value in the drop down list is expressed in binary
	format, you can choose to meet your network
	environment.

DSCP Signal	Select the DSCP value for SIP message, the value in
	the drop down list is expressed in binary format, you
	can choose to meet your network environment.

ToS Setting

ToS RTP	Select the ToS value for RTP (voice packets), the
	value in the drop down list is expressed in binary
	format, you can choose to meet your network
	environment.

ToS Signal	Select the ToS value for SIP messages, the value in
	the drop down list is expressed in binary format, you
	can choose to meet your network environment.

1.Press the “Apply” button (at the bottom) after you finish to save changes.

2.Press the “Reboot” button to apply the changes.

27

Image 28

Contents IP Telephony Gateway Online Upgrade Table of Content Web AdministrationIntroduction StartupSpecification OperationKey Features IntroductionLED Indicators Physical DescriptionSP5058A SP5018ASP5008A T1-T8L1-L8 T1/P1-T4/P4Login into the System StartupPage Network Configuration WAN Setting DhcpEnable/Disable this option Static IPDhcp PPPoE LAN Setting DescriptionDescription General configuration Pabx Mode SP5018A onlySIP Setting Pabx ConnectionPrimary FXS SIP settings FXO Dialing PrefixSIP Setting Password AccountNumber Display nameSIP Advanced Setting Make sure your proxy server or soft switch Supports the feature, if the proxy does not supportIt and you enable this feature, all IP outgoing calls Feature is for FXS onlyPayload Type Setting Page Line Setting Enable Hotline No Answer Forward Time FXS onlyLine1~Line8 relevant data Type RegPage Qos Setting Differentiated Services Code Point Setting DscpDscp Signal ToS Setting ToS RTPSpeed Dial Speed Dial SettingSpeed Dial Editor Peer to Peer call Speed Dial Editor In P2P applicationCaller ID Setting Caller ID Setting Line 1~LineDtmf Caller ID Start Symbol Dtmf Caller ID End SymbolDefault symbol is C CDR Setting CDR mode CDR Server address CDR Server portPage Syslog Setting Syslog mode Syslog Server address Syslog Server portPage Advanced Configuration System settingPage Page Ping ip to keep alive network Ping timersec Sntp Setting Codec Setting Codec PriorityCodec Packet Size Bandwidth RequiredVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Min. Digit Count CountryDigit Manipulation FXO Dial Prefix Dial Plan Editor Dial PlanThird Example Page Management Provision ServerSave-Reload setting Export File Import FileUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Network Status Displays the MAC address of the WAN portBoot version Version InfoPost version Application versionPort Type Port StatusRegister Proxy Password Current passwordNew password Confirm new passwordRebooting the system Configuration Peer to Peer mode FXO to FXSEnable the representative line All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking