NEC SP5008A user manual Dial Plan Editor, Third Example

Page 51

3.2.8 Dial Plan

Dial Plan Editor

Using this feature, users can specify the number that will be immediately dialed out without having to press the “#” (at the end of the dialed number) on the keypad or until the dial time timeout period. The number can be specified depending on the length of the dialed number, or the prefix of the dialed number.

For example, if the user sets:

First Example

zFunction: Enable

zLeading digit: 02

zTotal Digit count: 10

If the user dials a 10 digit number with a prefix of 02 (e.g. 0282265699), the MICRONET SP5008A / SP5018A / SP5058A will immediately detect it and dial this number straight away.

Second Example

zFunction: Enable

zLeading digit:

zTotal digit count: 8

If the user dials an 8 digit number (e.g. 82265699), the MICRONET SP5008A / SP5018A / SP5058A will immediately detect it and dial this number straight away.

Third Example

zFunction: Disable

50

Image 51

Contents IP Telephony Gateway Online Upgrade Startup Table of ContentWeb Administration IntroductionOperation SpecificationIntroduction Key FeaturesSP5018A LED IndicatorsPhysical Description SP5058AT1/P1-T4/P4 SP5008AT1-T8 L1-L8Startup Login into the SystemPage Network Configuration Dhcp WAN SettingStatic IP Enable/Disable this optionDhcp PPPoE Description LAN SettingDescription Pabx Connection General configurationPabx Mode SP5018A only SIP SettingFXO Dialing Prefix Primary FXS SIP settingsSIP Setting Display name PasswordAccount NumberSIP Advanced Setting Feature is for FXS only Make sure your proxy server or soft switchSupports the feature, if the proxy does not support It and you enable this feature, all IP outgoing callsPayload Type Setting Page Line Setting Reg Enable HotlineNo Answer Forward Time FXS only Line1~Line8 relevant data TypePage ToS Setting ToS RTP Qos SettingDifferentiated Services Code Point Setting Dscp Dscp SignalSpeed Dial Setting Speed DialSpeed Dial Editor Speed Dial Editor In P2P application Peer to Peer callDtmf Caller ID End Symbol Caller ID SettingCaller ID Setting Line 1~Line Dtmf Caller ID Start SymbolDefault symbol is C CDR mode CDR Server address CDR Server port CDR SettingPage Syslog mode Syslog Server address Syslog Server port Syslog SettingPage System setting Advanced ConfigurationPage Page Ping ip to keep alive network Ping timersec Sntp Setting Bandwidth Required Codec SettingCodec Priority Codec Packet SizeVoice Setting You can set this option for each of the 8 lines Tone Setting Disconnect tone Phone Setting Country Min. Digit CountDigit Manipulation FXO Dial Prefix Dial Plan Dial Plan EditorThird Example Page Provision Server ManagementExport File Import File Save-Reload settingUpgrade Firmware Updating the firmware by FTP Updating the firmware by Tftp Updating the firmware by Http Reset to Default Displays the MAC address of the WAN port Network StatusApplication version Boot versionVersion Info Post versionPort Status Port TypeRegister Proxy Confirm new password PasswordCurrent password New passwordRebooting the system Peer to Peer mode FXO to FXS ConfigurationEnable the representative line All the line and Disable all the register Enable the representative line Line 1~Line 8 Side B Peer to Peer mode FXS to FXS Page Page Page Specification SP5018A SP5058A Networking