Panasonic KX-TG6521E During a power failure, Battery level Icon, Operation Operating time

Page 12

TG6511-6521E(e).book Page 12 Monday, January 11, 2010 8:48 AM

Getting Started

Note when setting up

Note for connections

L The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.)

L The AC adaptor should be connected to a vertically oriented or floor- mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected.

During a power failure

The unit will not work during a power failure. We recommend connecting a corded-type telephone (without AC adaptor) to the same telephone line or to the same telephone line jack using a T- adaptor. Your Panasonic sales shop can offer you more information about connection possibilities.

Note for battery installation

L Use the supplied rechargeable batteries. For replacement, we recommend using the Panasonic rechargeable batteries noted on page 4, 8.

LWipe the battery ends (S, T) with a dry cloth.

L Avoid touching the battery ends (S, T) or the unit contacts.

Note for battery charge

L It is normal for the handset to feel warm during charging.

L Clean the charge contacts of the handset, base unit, and charger with a soft and dry cloth once a month. Clean more often if the unit is exposed to grease, dust, or high humidity.

Battery level

Icon

Battery level

&High

( Medium ) Low

0)4 Needs charging.

Panasonic Ni-MH battery performance (supplied batteries)

Operation

Operating time

In continuous

18 hours max.

use

 

Not in use

170 hours max.

(standby)

 

Note:

L It is normal for batteries not to reach full capacity at the initial charge. Maximum battery performance is reached after a few complete cycles of charge/discharge (use).

L Actual battery performance depends on usage and ambient environment.

L Even after the handset is fully charged, the handset can be left on the base unit or charger without any ill effect on the batteries.

L The battery level may not be displayed correctly after you replace the batteries. In this case, place the handset on the base unit or charger and let it charge for at least 7 hours.

12Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333

Image 12
Contents Before initial use, see Getting Started on Caller ID Service Voice Mail ServiceIntroduction Important InformationAccessory information Supplied accessoriesModel composition Additional/replacement accessories Accessory item Model numberExpanding your phone system Sales and support information Customer Care CentreGeneral information For your future referenceDeclaration of Conformity For your safety Important safety instructions Other information Operating conditions Setting up Battery installationBattery charge ConnectionsDuring a power failure Battery level IconOperation Operating time Controls HandsetBase unit Secure gripDisplay KX-TG6521/KX-TG6522/ KX-TG6523/KX-TG6524Charge contacts Speaker Erase Stop Handset display items MeaningTurning the power on/off LineUse Initial settings One touch eco modeSymbol meaning Example V/ Off Display languageMaking calls Answering callsUseful features during a call HoldMute Recall/flashKey lock Handset phonebook Copying phonebook entries Copying an entryCopying all entries Programmable settings Programming by scrolling through the display menusRinger Setup *2 Ringer Volume Handset Base Unit *1 RingtoneKX-TG6523 KX-TG6524 Programming using the direct commands Recall/Flash *9 Msec # 160 msec Privacy Mode *10 Base Unit PIN 0000 Repeater ModeCancel Register Display English DefaultTG6511-6521Ee.book Page 26 Monday, January 11, 2010 848 AM Alarm Special programmingChanging the handset name Incoming call barring Caller ID subscribers onlyRegistering a unit Changing the base unit PIN Personal Identification NumberOperating additional units Registering a handset to the base unitSetting the repeater mode Increasing the range of the base unitKX-TG6511/KX-TG6512/ KX-TG6513 Deregistering a handsetUsing Caller ID service Caller ID featuresCaller list Viewing the caller list and calling backEditing a caller’s phone number before calling back Erasing selected caller informationErasing all caller information Storing caller information to the phonebookAnswering system Turning the answering system on/offMemory capacity including your greeting message Call screeningListening to messages using the base unit Greeting messageListening to messages using the handset Erasing all messagesOperating the answering system Calling back Caller ID subscribers onlyRemote access code Using the answering system remotelyRemote commands Remote operationSettings Number of rings beforeUnit answers a call Turning on the answeringCaller’s recording time Selecting Greeting OnlyVoice mail service Intercom Transferring calls Conference callsHandset locator Making an intercom callWhen the unit displays the character entry screen Character entryCharacter entry modes Extended 1 character table N Extended 2 character table OError messages Troubleshooting General use Problem Cause/solutionProgrammable settings Problem Cause/solution Problem Cause/solution Battery recharge Problem Cause/solutionMaking/answering calls, intercom Answering system is being used. *1 Wait Caller ID Problem Cause/solution Unit does not record new Liquid damage Problem Cause/solution Wall mountingConditions of guarantee Panasonic Business Systems U.KIndex TG6511-6521Ee.book Page 51 Monday, January 11, 2010 848 AM Sales Department Copyright