Programming
2Base unit:
Proceed with the operation for your model.
■KX-TG6511/KX-TG6512/ KX-TG6513
Press and hold {x} for about 5 seconds. (No registration tone)
■
L If all registered handsets start ringing, press the same button to stop. Then repeat this step.
L The next step must be completed within 90 seconds.
3Handset:
Wait until “Base PIN” is displayed. iEnter the base unit PIN (default: “0000”). i M
L If you forget your PIN, see page 44.
L When the handset has been registered successfully, w is displayed.
Note:
L While registering, “Base in registering” is displayed on all registered handsets.
L When you purchase an additional handset, refer to the additional handset’s installation manual for registration.
Deregistering a handset
A handset can cancel its own registration (or the registration of another handset) that is stored to the base unit. This allows the handset to end its wireless connection with the system.
18i {#}{1}{3}{1}
L All handsets registered to the base unit are displayed.
2{V}/{^}: Select the handset you want to cancel. i M
3{V}/{^}: “Yes” i M
L A confirmation tone sounds.
L The handset does not beep when cancelling its own registration.
4{ic}
Increasing the range of the base unit
You can increase the signal range of the base unit by using a DECT repeater. Please use only the Panasonic DECT repeater noted on page 4. Contact your Panasonic dealer for details.
Important:
L Before registering the repeater to this base unit, you must turn the repeater mode on.
L Do not use more than one repeater at a time.
Setting the repeater mode
18i {#}{1}{3}{8}
2{V}/{^}: Select the desired setting. i Mi {ic}
Note:
L After turning the repeater mode on or off, _is displayed on the handset momentarily. This is normal and the handset can be used once w is displayed.
|
|
| Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333 | 29 |
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|