Panasonic KX-TG6521E operating instructions Error messages

Page 42

TG6511-6521E(e).book Page 42 Monday, January 11, 2010 8:48 AM

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message

Cause/solution

Check Phone Line

L The supplied telephone line cord has not been

 

connected yet or not connected properly. Check the

 

connections (page 11).

Error*1

L Recording was too short. Try again.

Failed

L Phonebook copy failed (page 21). Confirm the other

 

handset (the receiver) is in standby mode and try

 

again.

Incomplete

L The receiver’s phonebook memory is full. Erase the

 

unnecessary phonebook entries from the other

 

handset (the receiver) and try again.

Memory Full

L The phonebook memory is full. Erase unnecessary

 

entries (page 20).

 

L Message memory is full. Erase unnecessary

 

messages (page 33, 34).*1

 

L The call barred list memory is full. Erase unnecessary

 

entries (page 28).*1

Base no power

L The handset has lost communication with the base

or

unit. Move closer to the base unit and try again.

No link.

L Unplug the base unit’s AC adaptor to reset the unit.

Reconnect AC

Reconnect the adaptor and try again.

adaptor.

L The handset’s registration may have been cancelled.

 

Re-register the handset (page 28).

Use rechargeable

L A wrong type of battery such as Alkaline or

battery.

Manganese was inserted. Use only the rechargeable

 

Ni-MH batteries noted on page 4, 8.

You must first

L You must subscribe to a Caller ID service. Once you

subscribe to

receive caller information after subscribing to a Caller

Caller ID.

ID service, this message will not be displayed.

*1 KX-TG6521/KX-TG6522/KX-TG6523/KX-TG6524

42Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333

Image 42
Contents Before initial use, see Getting Started on Introduction Caller ID ServiceVoice Mail Service Important InformationAccessory information Supplied accessoriesModel composition Additional/replacement accessories Accessory item Model numberExpanding your phone system Sales and support information Customer Care CentreGeneral information For your future referenceDeclaration of Conformity For your safety Important safety instructions Other information Operating conditions Battery charge Setting upBattery installation ConnectionsDuring a power failure Battery level IconOperation Operating time Base unit ControlsHandset Secure gripCharge contacts Speaker Erase Stop DisplayKX-TG6521/KX-TG6522/ KX-TG6523/KX-TG6524 Handset display items MeaningTurning the power on/off LineUse Symbol meaning Example V/ Off Initial settingsOne touch eco mode Display languageMaking calls Answering callsMute Useful features during a callHold Recall/flashKey lock Handset phonebook Copying phonebook entries Copying an entryCopying all entries Programmable settings Programming by scrolling through the display menusRinger Setup *2 Ringer Volume Handset Base Unit *1 RingtoneKX-TG6523 KX-TG6524 Programming using the direct commands Cancel Register Display English Recall/Flash *9 Msec # 160 msec Privacy Mode *10Base Unit PIN 0000 Repeater Mode DefaultTG6511-6521Ee.book Page 26 Monday, January 11, 2010 848 AM Changing the handset name AlarmSpecial programming Incoming call barring Caller ID subscribers onlyOperating additional units Registering a unitChanging the base unit PIN Personal Identification Number Registering a handset to the base unitKX-TG6511/KX-TG6512/ KX-TG6513 Setting the repeater modeIncreasing the range of the base unit Deregistering a handsetCaller list Using Caller ID serviceCaller ID features Viewing the caller list and calling backErasing all caller information Editing a caller’s phone number before calling backErasing selected caller information Storing caller information to the phonebookMemory capacity including your greeting message Answering systemTurning the answering system on/off Call screeningListening to messages using the base unit Greeting messageOperating the answering system Listening to messages using the handsetErasing all messages Calling back Caller ID subscribers onlyRemote commands Remote access codeUsing the answering system remotely Remote operationUnit answers a call SettingsNumber of rings before Turning on the answeringCaller’s recording time Selecting Greeting OnlyVoice mail service Handset locator Intercom Transferring callsConference calls Making an intercom callWhen the unit displays the character entry screen Character entryCharacter entry modes Extended 1 character table N Extended 2 character table OError messages Troubleshooting General use Problem Cause/solutionProgrammable settings Problem Cause/solution Problem Cause/solution Battery recharge Problem Cause/solutionMaking/answering calls, intercom Answering system is being used. *1 Wait Caller ID Problem Cause/solution Unit does not record new Liquid damage Problem Cause/solution Wall mountingConditions of guarantee Panasonic Business Systems U.KIndex TG6511-6521Ee.book Page 51 Monday, January 11, 2010 848 AM Sales Department Copyright