TCD440_445AL(E).book Page 33 Monday, May 24, 2004 1:17 PM
L If you changed PIN, enter it (page 24).
8Press {>}.
L When the handset has been registered successfully, a confirmation tone will sound, and w will stop flashing.
Note:
L If all registered handsets start ringing in step 5, press {x} to stop, then start again from step 1.
Selecting a base unit
When “AUTO” is selected, the handset will automatically use any available base unit it is registered to. When a specific base unit is selected, the handset will make and receive calls using that base unit only. If the handset is out of range of that base unit, no calls can be made.
1Press {j}.
2Press {v} repeatedly to display “SETTING HS”, then press {>}.
3Press {v}repeatedly to display “SELECT BS”, then press {>}.
4Press {v} repeatedly to display “AUTO” or a specific base unit number, then press {>}.
L The handset starts searching for the base unit.
Note:
L When a handset is registered to another base unit, this setting will automatically change to that base unit’s number even if “AUTO” was selected.
Cancelling a handset
A maximum of 6 handsets can be registered to a base unit. A handset can cancel its own registration (or the registration of another handset) that is stored in the base unit. This will allow the base unit to “forget” the handset.
1Press {j}.
2Press {v} repeatedly to display “SETTING BS”, then press {>}.
3Press {7}.
4Enter “0000” (default base unit PIN).
L If you changed PIN, enter it (page 24).
5Press the desired handset number.
L The selected handset number will flash.
6Press {>}.
7Wait until “SETTING BS” is displayed, then press {ih}.
Cancelling a base unit
A handset can be registered to a maximum of 4 base units. A handset can cancel a base unit that it is registered to. This will allow the handset to “forget” that base unit.
1Press {j}.
2Press {v} repeatedly to display “SETTING HS”, then press {>}.
3Press {v} repeatedly to display
“REGISTRATION”, then press {>}.
4Press {v}repeatedly to display “CANCEL BS”, then press {>}.
5Enter “0000” (default handset PIN).
L If you changed PIN, enter it (page 23).
6Press {v} repeatedly to select the desired base unit number, then press
{>}.
L The selected base unit number will flash.
7Press {>}.
8Press {v} repeatedly to select “YES”, then press {>}.
L To stop cancelling, select “NO”.
9Press {ih}.
Note:
L To register the handset to another base unit or to the same base unit again, see manual registration (page 32).
33