TCD440_445AL(E).book Page 5 Monday, May 24, 2004 1:17 PM
Preparation
Instructions to customer
Installation
Attached to this telephone is an approval label. This label is evidence that it is a “Permitted Attachment” which has been authorised to be connected to your telephone service. Conditions relating to connection and operation of this Permitted Attachment are contained in Telecommunications General
You are authorised to install this Permitted Attachment yourself by plugging it into the line socket of any regular telephone. You may connect it in place of your existing telephone or to any spare telephone socket installed in your premises.
To disconnect your existing telephone you must first remove its plug from the line socket. You can then insert the plug of your Permitted Attachment into the socket and use your equipment.
If the plug of your existing telephone cannot be readily removed, you will have to remove the screw securing it. To do this proceed as follows:
1Loosen screw “A” sufficiently to remove the socket cover. (See Fig. 1.)
2Remove screw “B” and withdraw the plug. (See Fig. 2.)
3Replace screw “B”. (See Fig. 3.) Ensure that it screws completely into the socket recess. (If the screw is too long, increase the hole depth or replace the screw with one 5 mm shorter.)
4Replace socket cover and tighten screw “A”. (See Fig. 4.)
SOCKET PLUG |
| ||
|
| SCREW | |
SCREW “A” |
| “B” | |
Fig. 1 | TELEPHONE CORD | Fig. 2 | |
Connect to the PLUG | |||
| ) | ||
| (as shown in Fig. 1. | ||
|
| SCREW “A” | |
| SCREW |
| |
| “B” | SOCKET | |
Fig. 3 |
| Fig. 4 | |
5