MAINTENANCE & SAFETY
PRECAUTIONS & GENERAL MAINTENANCE
•Place the set on a hard and flat surface so the system does not tilt.
•Do not expose the set, batteries or CD to humidity, rain, sand or excessive heat caused by heating equipment or direct sunlight.
•Do not cover the set. Adequate ventilation with a minimum gap of 15 cm between the ventilation holes and surrounding surfaces is necessary to prevent heat
•The mechanical parts of the set contain selflubricating bearings and must not be oiled or lubricated.
•To clean the set use a soft dry cloth. Do not use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the housing.
CD PLAYER AND CD HANDLING
•The lens of the CD player should never be touched!
•Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD us then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.
•Always close the CD door to keep the CD Compartment
•To clean the CD, wipe in a straight lien from the center towards the edge using a soft,
•Never write on a CD or attach any stickers on it.
TROUBLESHOOTING
TROUBLESHOOTING
If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
-Problem
• Solution
NO SOUND/POWER
-Volume not adjusted
• Adjust the volume
-Power cord not securely connected
• Connect the AC power cord properly
-Batteries dead/incorrectly inserted
• Insert (fresh) batteries correctly
DISPLAY DOES NOT FUNCTION PROPERLY / NO REACTION TO OPERATION OF ANY THE CONTROL
-Electrostatic discharge
• Switch off and unplug the set. Reconnect after a few seconds
15.