XP AZ 1018/17
| Cassette Recorder |
Programming track numbers
You may store up to 20 tracks in the desired sequence. If you like, store any track more than once.
VOLUME |
BATT |
LOW |
PLAY- |
PAUSE |
STOP |
CDMODE |
PROGRAM |
FM•AM |
SE |
AR |
CH |
PRESET |
1In the STOP mode, press SEARCH ∞ or § for your desired track.
2When your chosen track number appears, press CD MODE/ PROGRAM once to store the track.
➜ The display shows PROGRAM and 'Prog' briefly followed by your selected track number.
➜ If you attempt to program without first selecting a track number, no SEL is shown.
3Repeat steps 1 to 2 to select and store all desired tracks in this way.
➜ FULL is displayed if you attempt to program more than 20 tracks.
4To play your program, press PLAY•PAUSE 2;.
Reviewing your program
•In the STOP mode, press and hold down CD MODE/ PROGRAM for more than one second.
➜The display shows all your stored track numbers in sequence.
Erasing a program
You can erase the contents of the memory by:
–opening the CD door;
–selecting RADIO or TAPE source;
–pressing STOP 9 (twice during playback
or in the stop position.)
➜ Display: shows 'no Prog' briefly when the program is cancelled.
CASSETTE RECORDER
Cassette playback
AZ1018 |
VOLUME |
BATT |
LOW |
PLAY- |
PAUSE |
STOP |
CDMODE |
PROGRAM |
FM•AM |
SE |
AR |
CH |
PRESET |
1Adjust the POWER slider to TAPE/OFF.
2Press STOP•OPEN 9/ to open the cassette door and insert a recorded cassette.
3Close the cassette door.
4Press PLAY 1 to start playback.
➜Display: shows tAPE throughout tape operation.
5To pause playback press PAUSE ;.To resume, press the key again.
6By pressing 5 or 6, fast winding of the tape is possible in both directions.To stop fast winding, press STOP•OPEN 9/.
7To stop the tape, press STOP•OPEN 9/.
•The keys are automatically released at the end of the tape, the tAPE indication goes out and the set is switched off, except if PAUSE ; has been activated.
English
13