Philips 1018 Power Supply, Using AC Power, Switching power on/off Save energy, General operation

Page 9

XP AZ 1018/17 14-11-2000 19:17 Pagina 9

Power Supply

Batteries contain chemical substances, so they should be disposed of properly.

Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the batteries to burst.Therefore:

•Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.

•When inserting new batteries, do not try to mix old batteries with the new ones.

•Remove the batteries if the set is not to be used for a long time.

Using AC Power

1Check if the power voltage, as shown on the type plate located on the bottom

C MAIN	S ~
A

Switching power on/off:

Save energy

Whether you are using mains or battery supply, to avoid unnecessary energy consumption always adjust the POWER slider to TAPE/OFF and check if the cassette keys are released.

AZ1018

VOLUME

BATT

LOW

PLAY-

PAUSE

STOP

CDMODE

PROGRAM

FM•AM

SE

AR

CH

PRESET

General operation

1To select your sound source adjust the POWER slider to CD, RADIO or TAPE/OFF.

2Adjust the sound with the VOLUME and DBB (Dynamic Bass Boost) controls.

3To switch off the set, adjust the POWER slider to TAPE/OFF position and check the cassette keys are released.

English

of the set, corresponds to your local

Note:When the set is switched off the tuner presets will be retained in the set’s memory.

power supply. If it does not, consult your dealer or service center.

2Connect the power cord to the AC MAINS inlet and the wall outlet.The power supply is now connected and ready for use.

3To switch off completely, unplug the power cord from the wall outlet.

•Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.

The type plate is located on the bottom of the set.

9

Image 9

Contents CD Radio Cassette Recorder Model No Serial No For Customer UsePagina Contents English Français21 Español IndexRead before operating equipment Use only with a cart, standEL 6475-E001 00/8 Limited Warranty Top and front panels ControlsUsing AC Power Power SupplySwitching power on/off Save energy General operationRadio reception RadioAdjust the Power slider to CD Display shows Cd brieﬂy CD-PlayerPlaying a CD Track Selecting a different trackFinding a passage within a track Shuffle Repeat ALL repeatsProgramming track numbers Adjust the Power slider to TAPE/OFFReviewing your program Erasing a programGeneral information on recording RecordingPrecautions General Maintenance MaintenanceTape deck maintenance CD player and CD handlingProblem Solution TroubleshootingCet espace vous est réservé Inscrivez ci-dessous le numéro de série situéDe modèle De série Informations générales CommandesAlimentation Lecteur de CDLire avant toute utilisation du matériel Ninstallez pas lappareil près duneProtégez le cordon dalimentation Conservez ces instructions. Il estGarantie Limitée Panneaux supérieur et avant CommandesAlimentationAlimentation Secteur Panneau arrière Antenne télescopique améliore laMise en/hors service Economie d’énergie AlimentationUtilisation de lalimentation à courant alternatif Réception radio Lecteur de CD Lecture d’un CDRéglez le curseur d’alimentation sur CD Différents modes de lecture Recherche d’un passage au sein d’une plageLecteur de cassette Lecteur de CD Platine CassettePassage en revue du programme Effacement dun programmeEnregistrement Synchro Start CD EnregistrementPour sélectionner et enregistrer un Passage spéciﬁque Enregistrement à partir de la radioEnregistrementEntretien Précautions Entretien GénéralEntretien du lecteur de CD et des CD Depistage des Anomalies Probleme RemèdeNo. de modelo No. de serie Para uso del clienteÍndice No anule la seguridad De la clavija de Seguridad Léalas antes de poner en marcha el equipoCorriente ya sea de tipo Coloque el equipo Exclusivamente sobre aquellosGarantia Limitada Controles Alimentación Paneles superior y frontalSuministro de Energía Utilización de la energía CA Encendido/apagado Ahorre energíaFuncionamiento general Para seleccionar la fuente de sonido, pongaRecepción de radio Reproductor de CD Reproducción de un CDPonga el conmutador deslizable a CD Posición de parada o pausa, pulse Para seleccionar otra pista diferentePlaypause 2 para iniciar la ReproducciónReproductor de CD Grabadora del Casete Información general sobre la grabación GrabaciónComienzo de la grabación sincronizada Selección y grabación de un pasaje particularPrecauciones Mantenimiento General MantenimientoMantenimiento de la platina Reproductor de CD y manejo de unProblema Solución Resolución de problemasMeet Philips at the Internet Philips Consumer Electronics Company