JVC MX-WMD90 manual For Canada/pour le Canada, Face

Page 3

For Canada/pour le Canada

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR EVITER LES CHOCS ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND.

For Canada/pour le Canada

THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED “DIGITAL APPARATUS,” ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS.

CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMIRIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR: “APPAREILS NUMERIQUES”, NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS.

Caution: Proper Ventilation

To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

1 Front:

No obstructions and open spacing.

2 Sides/ Top/ Back:

No obstructions should be placed in the areas shown by the dimensions below.

3 Bottom:

Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm (3 15/16 in.) or more.

Front view

15 cm

Face

(5 15/16 in.)

15 cm

1 cm

1 cm

(7/16 in.)

(7/16 in.)

(5

15/16 in.)

Attention: Aération correcte

Pour prévenir tout risque de décharge électrique ou d’incendie et éviter toute détérioration, installez l’appareil de la manière suivante:

1 Avant:

Bien dégagé de tout objet.

2 Côtés/dessus/dessous:

Assurez-vous que rien ne bloque les espaces indiqués sur le schéma ci-dessous.

3 Dessous:

Posez l’appareil sur une surface plane et horizontale. Veillez à ce que sa ventilation correcte puisse se faire en le plaçant sur un support d’au moins dix centimètres

(3 15/16 po.) de hauteur.

			Side view
			Side view
			Côté			15 15cmcm
						15 15cmcm
	15 cm		15 cm			(5 15/16 in.)
	(5 15/16 in.)		(5 15/16 in.)
	(5 15/16 in.)		(5 15/16 in.)

CACA-WMD9-D3S0

CA-WMD90

CA-D3S

10cm

10 cm

(3 15/16 in.)

– G-2 –

Image 3

Contents MX-WMD90 Mises en garde, précautions et indications diverses Face For Canada/pour le CanadaIntroduction PrecautionsContents Become familiar with the buttons and controls on your unit Location of the Buttons and ControlsFront Panel Display WindowMD deck B section Front PanelAmplifier/tuner section MD deck a sectionRemote Control Remote ControlUnpacking Putting the Batteries into the Remote ControlConnecting Antennas Getting StartedTo connect an outdoor AM antenna Connecting SpeakersYou can connect the speakers using the speaker cords AM antennaTo connect a cassette deck Connecting Other EquipmentPress Demo Output terminalTo start the display demonstration manually Equipment FinallyBasic and Common Operations Front panel Remote controlTo adjust the clock again Setting the ClockTurning On the Power and Selecting the Sources Adjusting the VolumeActivating the Surround Effect Creating Your Own Sound Mode Manual ModeTo use your own sound mode Reinforcing the Bass SoundListening to FM and AM Broadcasts To change the FM reception mode Tuning in a StationPresetting Stations Tuning in a Preset StationPlaying Back CDs To exchange CDs during playback of another Loading CDsPlaying Back the Entire Discs Continuous Play Basic CD OperationsTo go to another track To go to another track directly using the number buttonsTo check the program contents Programming the Playing Order of the Tracks Program PlayTracks of all loaded CDs will play at random Playing at Random Random PlayRepeating Tracks or CDs Repeat Play Prohibiting Disc Ejection Disc LockPlaying Back MDs Playing Back the Entire MD Continuous Play When using MD deck aWhen using MD deck B Loading MDsBasic MD Operations To change the display IndicationsWhile playing an MD, you can do the following operations Programming the Playing Order Tracks Program PlayInsert an MD Insert MDs Press #/ 8 on MD deck B or MD B 6 on the remote controlRepeating Tracks Repeat Play To prohibit disc ejection Disc LockTracks of the loaded MDs will play at random FM/AM Tape AUX Recording on MDsRecording is only possible on MD deck B Before You Start RecordingAbout the track marks To avoid erasing important recordingsPress AUX again When recording from the cassette deck, start playing a tapeRecording the External AUX Equipment AUX Recording To check the remaining timeStart playing the source on the external equipment Various Recording FunctionsSynchronized Recording MD to MD Synchronized RecordingOn the unit only Load a CD To confirm the recording contentsCD to MD Synchronized Recording Press Start EnterRotate the left jog dial to select the recordable MD Single Track RecordingFirst Track Recording On the unit only Load CDsTo stop any time during editing process and start Listening Edit RecordingOn the unit only Prepare a CD or an MD as the source sound Repeat to program other tracksTriple Recording Prepare the source you want to record from Long RecordingEditing MDs Introducing MD Editing Functions Divide Function Press MD EditTo join the divided tracks again, see the Join function Rotate the right jog dial until Move ? appears Press SET Join FunctionMove Function To divide the joined tracks, see the Divide functionMD deck B starts playing the MD CANCEL, then select the correct track number againErase Function EditALL Erase Function Assigning Titles to MDs Assigning a Title Using the Unit Make sure that the character you want to change is flashing Changing the TitlePress Enter Start to finish the current title entry You can make a correction or change the titlePress Enter to finish the current title entry Track title entry indication mode appears whenPress MD Title Input Press the button for the next character you want to inputYou can assign titles during play or recording PO WER Using the TimersTo turn on the Recording Timer, press SET Using Recording TimerHow Recording Timer actually works To turn on or off Recording Timer after its setting is doneUnit is turned off Using Daily TimerHow Daily Timer actually works Volume level will be set the previous level whenTimer Priority Using Sleep TimerHow Sleep Timer actually works Handling CDs MaintenanceTo clean the CD General NotesAtrac Adaptive TRansform Acoustic Coding Utoc User Table Of ContentsAdditional Information MD Disc TypesMD limitations Sound Skip Guard MemorySymptom Possible Cause Action TroubleshootingMD Messages Signification SolutionSpecifications EN, FR JVC 0199KSMMDWJEM