Philips XP AJ 3430 manual Installation, Basic Features

Page 7

INSTALLATION

POWER SUPPLY AND DEMO MODE

1.Check if the power voltage, shown on the type plate on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center.

2.Connect the power plug into the wall outlet. The power supply is now switched on and the display will show the PHILIPS demo mode.

PH..IL ..IPS scrolls across the display continuously.

Turn the SET control to SET TIME to exit the demo mode.

3. To disconnect the set completely from the power supply, withdraw the power plug from the wall outlet.

POWER BACK-UP

The power back-up conveniently allows your preset stations, alarm and clock time settings to be stored for up to 3 minutes when there is a power interruption e.g. AC power failure. The complete clock radio and display illumination will be switched off. As soon as the power supply returns, the display will indicate the correct time.

If power supply returns after 3 minutes and the display shows:

clock time blinking – indicates you need to re-adjust the clock time

PHILIPS demo mode – indicates you need to re-enter preset stations and the clock and alarm times.

BASIC FEATURES

ILLUMINATION BRIGHTNESS

1.Check if the SET control is turned to CLOCK position and the radio is switched off.

2.Press REPEAT ALARM/ BRIGHTNESS CONTROL once or more.

The brightness of the display will change in this sequence:

BRIGHT y MEDIUM y LOW y BRIGHT...

Note:

when an alarm or the SLEEP function is active, brightness cannot be adjusted.

RESET

Should the display and electronic functions of your set receive interference e.g. static electricity from carpets, thunderstorms, etc. RESET allows you to clear all previous settings and start up again.

Use a ballpoint pen to press the RESET hole found on the bottom of the set.

English

7

Image 7
Contents Clock Radio Know these ssaaffeettyy symbols Safety123 567 EL 4562-E004 99/3 Français EnglishFrançais SLEEP/ Radio on Alarm RESET/ Radio OFFVolume ControlsBasic Features InstallationRadio Setting the ClockTuning to Radio Stations Storing and Using Preset StationsHour alarm reset Using the AlarmSetting the Alarm Time and Mode Switching OFF the AlarmAbout Sleep Setting SleepMaintenance SleepAlarm does not function Display error/ no reaction to any controlsWhere is Exchange AVAILABLE? Limited WarrantyWHO is COVERED? What is COVERED? What is EXCLUDED?Exchanging a Product in Canada To GET OUT-OF-WARRANTY ExchangeRemember Remarques SécuriteEL 4562-E004 99/3 Commandes Luminosite Declairage Reset réinitialisationFonctions DE Base Memoire AutonomeRecherche DE Stations Reglage DE LhorlogeMemorisation ET Selection DES Stations Prereglees Generalites Reglage DE Lheure ET DU Mode DE ReveilHour alarm reset Arrêt pendant 24 heures Emploi DU ReveilActivation DE LA Fonction Sleep Sommeil Arrêt définitif du réveilRépétition du réveil Propos DE LA Fonction Sleep SommeilCraquements continus/ sifflements pendant une émission AM ProblemeDepannage Pas de sonOÙ L’ÉCHANGE EST-ELLE Proposée ? Garantie LimitéeQUI EST Couvert ? QU’EST-CE QUI EST Couvert ?Rappel Important Avant DE Demander UNE ÉCHANGE…Pour Bénéficier D’UNE Échange Garantie AU CANADA… Pour UNE Échange Hors GARANTIE…Notas SeguridadEL 4562-E004 99/3 Controles Alimentación DE Salvaguarda InstalaciónCaracterísticas Básicas Alimentación Y Modo DE DemostraciónSintonización DE Emisoras Ajuste DEL RelojAlmacenamiento Y Selección DE Presintonías La pantalla muestra o Para Utilizar LA AlarmaAjuste DE LA Hora Y DEL Modo DE Alarma Desconexión DE LA AlarmaAjuste DEL Tiempo DE Sleep Cancelación de la alarma por completoRepetición de alarma Sobre LA Función DE SleepLa alarma no funciona Solución DE ProblemasProblema Error en la pantalla/ los controles no funcionan¿DONDE SE Efectua EL CAMBIO? Garantia Limitada¿QUIEN Tiene PROTECCION? ¿QUE CUBRE?RECUERDE… Antes DE Pedir UN CAMBIO…Para Cambiar UN Producto EN EL CANADA… Para Cambiar UN Producto Despues DE Vencer LA GARANTIA…English Français Español AJ 3430 Clock Radio