Friedrich SH14, SH20 installation manual Typical Installation Sill Plate, Slope down

The illustrations below show a standard frame construction installation as well as some suggested ways of adapting the support bracket to thick walls and large stone ledges.

TYPICAL INSTALLATION SILL PLATE

Figure 1	Figure 2
10 - 24 Screw
10 - 24 Flat Nut		3/8" (10 mm)
3/8" (10 mm)
		Slope down
Slope down
	Cut
	Here
		Stone ledge
#12A x 2" Sheet metal screw		Outside wall
1" x 2" or 2" x 4" spacer between wall		Cut to fit Dimension "A" and
	Discard shaded area	bend down to for a vertical leg
and bracket should be used on
aluminum, asbestos or vinyl siding
Figure 3	Figure 4
Stone ledge	Stone ledge
3/8" (10 mm)		3/8" (10 mm) Slope down
Slope down
#12A x 2" Sheet metal		Straighten tab to lay flat along
		the bottom rail of the shell.
screw		Secure the longest side of the
		bracket to the shell.
2" x 4" Spacer		Adjust in or out to rest on the ledge

STEP 4. CUTWINGBOARD PANELS: Measure and cut the wingboard panels from the supplied masonite (Item #8) to fit the spaces between the side window channels and the sides of the cabinet (See Figure F).

NOTE: AFTER CUTTING PANELS, MAKE A TRIAL TEST TO SEE IF THEY FIT THE SPACE WITH ABOUT 1/8" CLEARANCE BEFORE GOING TO STEP 5.

FIGURE F

Measure distance "B" to the inside of the channel on each side

Cut here and discard the center waste material

Wingboard

Subtract 1/8" (3 mm) from dimension "B" and measure from the edge of the wingboard (Item # 8), mark and cut with a saw.

Page 12