TOC
TOC
TROUBLESHOOTING & REPAIR | ||
|
|
|
PROTECTION BOARD OUTPUT TEST(cont.)
Return to Section
Return to Section TOC
Return to Master
Return to Master TOC
TEST PROCEDURE
8.With power OFF, disconnect J8 and attach voltage probes into back of wire harness lead junction block (J8). See Figure F.5.
Insert probes into back of the connection cavities for leads 313
NOTE:
With probes attached, plug the (J8) block into the PC board.
9.Turn main power ON.
10.Move Output Terminal Switch S4 to ON position on Control Panel.
11.Test for less than 1 VDC between leads 313
a.If less than 1 VDC is measured, test is OK and Protection Board is functioning properly.
b.If more than 5 VDC is measured, go to Static Capacitor Balance Test.
NOTE: During voltage test, be cautious when posi- tioning loose components to avoid shorts and dam- age to equipment.
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
FIGURE F.5 - INSERTING PROBES
L7915 | PROTECTION |
|
313
306
J8 | J15 |
|