Return to Section TOC
Return to Master TOC
A-6 INSTALLATIONA-6
OUTPUT CABLES
| 3. | Slide the copper tube into the brass plug. | |
Select the output cable size based upon the following | 4. | Insert cable into copper tube. | |
chart. | |||
| SET SCREW | ||
|
|
Cable sizes for Combined Length of Electrode and
Work Cable (Copper) 75° rated:
Return to Section TOC
Return to Master TOC
Duty |
| Length Up | |
Cycle | Current | 61m (200 ft.) | |
|
|
|
|
100% | 250 | 1/0 | 1/0 |
60% | 300 | 1/0 | 2/0 |
Quick Disconnect Plugs
A quick disconnect system is used for the welding cable connections. The welding plug included with the machine is designed to accept a welding cable size of 1/0 to 2/0.
1.Remote 25mm (1 in.) of welding cable insulation.
2.Slide rubber boot onto cable end. The boot end may be trimmed to match the cable diameter. Soap or other lubricant will help to slide the boot over the cable.
BRASS PLUG
COPPER TUBE
5.Tighten set screw to collapse copper tube. Screw must apply pressure against welding cable. The top of the set screw will be well below the surface of the brass plug after tightening.
6.Slide rubber boot over brass plug. The rubber boot must be positioned to completely cover all electrical surfaces after the plug is locked into the receptacle.
Return to Section TOC
Return to Section TOC
Return to Master TOC
Return to Master TOC
BOOT
WELDING CABLE
25 mm
TRIM
1 in.