Lincoln Electric IM 513-B manual Tion Sequence, For codes 10066

Page 10

ASSEMBLE INTO CLASSIC SERIES PIPELINER, SA-250 and 350SA INSTALLA-

TION SEQUENCE:

(For codes 10066, 10914)

1)Remove current range selector and fine current adjustment control knobs from front of machine. (small flat screwdriver and 3/32” Allen wrench.)

2)Remove 5 upper nameplate screws, or fastener buttons.

3)Break-off upper half of machine nameplate. Nameplate is scored for easy bending and break- off.

4)Install control panel assembly. (Wiring connec- tions will be made later).

5)Secure control panel assembly with (7) screws from the mounting hardware packet.(5/16” Nut Driver)

6)Reinstall current range selector and fine current adjustment control knobs to front of machine. (Small flat screwdriver and 3/32” Allen wrench).

7)(For Classic II models ONLY) Remove the side panel. (3/8” Socket wrench).

– 10 –

Image 10

Contents Wire Feed Module Safety Depends on YouSafety Electric Shock can kill Welding and Cutting Sparks can Cause fire or explosion IiiIvSAFETY Précautions DE SûretéThank You Table of Contents Recommended Wire Feeders and Accessories SpecificationsDesign Features General DescriptionEngine Exhaust can kill Installation InstructionsPre Installation Moving Parts can injureTion Sequence For codes 10066Page Page Page Page Page Assembly Into SAE-300 Welder Installation Sequence For CodePage Page Connection of the LN-7, LN-7 GMA to the Wire Feed Module Connection of Lincoln Electric Wire FeedersConnection of the LN-23P to the Wire Feed Module Wire Feed Module Operation MaintenanceTroubleshooting Chart Operating InstructionsTroubleshooting Trouble Causes What to doTroubleshooting Procedures for Replacing P.C. Boards Troubleshooting ProceduresC. Board Troubleshooting Procedures Procedure for Checking the Cold Tip Contactor CR4Remote Control Check Procedure for Checking the Capacitor Bank Contactor CR3Checking Voltage Control Potentiometer on Machine Quick Check Procedure for Generator Only Wire Feed Module Wiring Diagram Engine Welder M17323 1 0 3 1 0 3 Engine Welder Engine Welder Engine Welder with + CV Classic I and Pipeliner 200D and 200G with Wire Feed Module Classic II with Wire Feed Module = Wire Feeder OCV Volts LoadClassic III and 300G with Wire Feed Module = Wire Feeder OCV Volts Load SA and SA-250 Codes 10889 and below with Wire Feed Module Load Amps DCWire Feed Module Wire Feed Module Precaucion Warnung