Lincoln Electric IM 513-B manual

Page 11

8)Remove 2 screws from brush wraparound cover. Loosen and rotate the wraparound cover until neg- ative brushholder is exposed. (Large flat head screwdriver and pliers).

9)The negative brushholder is in the 11:00 position looking at the control panel end of the generator. Remove negative brushholder 5/16” bolt. (1/2” Socket, ratchet, and small extension.)

10)(NOTE:) If you are installing the WFM on the Classic I, you must change the “250H” thermostat to the thermostat marked “200”, (provided in the mounting hardware packet). Make certain the nut and bolt is tightened and the 608 and 609 leads are connected to the thermostat. (1/2” Socket, ratchet, and 1/2” open end.)

11)Position Wire Feed Module control box next to the right side of the machine (as shown). Place one plain washer (provided in the mounting hard- ware packet) over each mounting stud.

– 11 –

Image 11
Contents Safety Depends on You Wire Feed ModuleSafety Electric Shock can kill Iii Welding and Cutting Sparks can Cause fire or explosionPrécautions DE Sûreté IvSAFETYThank You Table of Contents General Description SpecificationsDesign Features Recommended Wire Feeders and AccessoriesMoving Parts can injure Installation InstructionsPre Installation Engine Exhaust can killFor codes 10066 Tion SequencePage Page Page Page Page For Code Assembly Into SAE-300 Welder Installation SequencePage Page Connection of the LN-23P to the Wire Feed Module Connection of Lincoln Electric Wire FeedersConnection of the LN-7, LN-7 GMA to the Wire Feed Module Operating Instructions MaintenanceTroubleshooting Chart Wire Feed Module OperationTrouble Causes What to do TroubleshootingTroubleshooting Procedure for Checking the Cold Tip Contactor CR4 Troubleshooting ProceduresC. Board Troubleshooting Procedures Procedures for Replacing P.C. BoardsChecking Voltage Control Potentiometer on Machine Procedure for Checking the Capacitor Bank Contactor CR3Remote Control Check Quick Check Procedure for Generator Only Wire Feed Module Wiring Diagram Engine Welder M17323 1 0 3 1 0 3 Engine Welder Engine Welder Engine Welder with + CV Classic I and Pipeliner 200D and 200G with Wire Feed Module = Wire Feeder OCV Volts Load Classic II with Wire Feed ModuleClassic III and 300G with Wire Feed Module = Wire Feeder OCV Volts Load Load Amps DC SA and SA-250 Codes 10889 and below with Wire Feed ModuleWire Feed Module Wire Feed Module Precaucion Warnung