Lincoln Electric IM 513-B manual

Page 13

15)Locate and remove 12-pin jumper plug and install 12-pin connector from control box to 12-pin con- nector. Connect control box 6-pin connector to control panel 6-pin connector. Connect control box 9-pin connector to control panel 9-pin con- nector.

For Classic 300D with Codes (11547, 11548, 11572, 11573) and Pipeliner 200D Code 11591. Remove U (BLUE) and 602C wires from flyback bridge. See machine wiring diagram. Keep U and 602C lead terminals connected and insulate with electrical tape.

16)For Classic I, III, IIID, 300D, 300G and SA250 (Codes 10889 and Below), 350 SA, Pipeliner 200D and 200G remove two (2) fuel tank hold down bolts on the right side of the machine and save hardware. (9/16” deep well socket, ratchet, and 9/16” open end wrench.) For the Classic II and SA250 (Codes 10890 and Above), do not remove the fuel tank hold down bolts. On these machines, the WFM mounts to the adjacent holes with two (2) 1” spacers, flat washer, lock washer and hex nuts, (provided in the mounting hardware packet).

17)For the Classic I & III, the carburetor choke cable must be unclamped at the frame. Reclamp at the flange provided on the WFM.

– 13 –

Image 13

Contents Safety Depends on You Wire Feed ModuleSafety Electric Shock can kill Iii Welding and Cutting Sparks can Cause fire or explosionPrécautions DE Sûreté IvSAFETYThank You Table of Contents Design Features SpecificationsRecommended Wire Feeders and Accessories General DescriptionPre Installation Installation InstructionsEngine Exhaust can kill Moving Parts can injureFor codes 10066 Tion SequencePage Page Page Page Page For Code Assembly Into SAE-300 Welder Installation SequencePage Page Connection of the LN-7, LN-7 GMA to the Wire Feed Module Connection of Lincoln Electric Wire FeedersConnection of the LN-23P to the Wire Feed Module Troubleshooting Chart MaintenanceWire Feed Module Operation Operating InstructionsTrouble Causes What to do TroubleshootingTroubleshooting C. Board Troubleshooting Procedures Troubleshooting ProceduresProcedures for Replacing P.C. Boards Procedure for Checking the Cold Tip Contactor CR4Remote Control Check Procedure for Checking the Capacitor Bank Contactor CR3Checking Voltage Control Potentiometer on Machine Quick Check Procedure for Generator Only Wire Feed Module Wiring Diagram Engine Welder M17323 1 0 3 1 0 3 Engine Welder Engine Welder Engine Welder with + CV Classic I and Pipeliner 200D and 200G with Wire Feed Module = Wire Feeder OCV Volts Load Classic II with Wire Feed ModuleClassic III and 300G with Wire Feed Module = Wire Feeder OCV Volts Load Load Amps DC SA and SA-250 Codes 10889 and below with Wire Feed ModuleWire Feed Module Wire Feed Module Precaucion Warnung