Lincoln Electric IM 513-B manual 1 0 3

– 29 –

CONNECTION DIAGRAM: CLASSIC II, III, IIID, 300D, 300G, SA-250, 350SA &

SAE-300 ENGINE WELDERS WITH WIRE FEED MODULE TO K867 PLUG TO LN-7.

ENGINE WELDER WITH		WARNING
115 VAC AUXILIARY			Turn off input power to the Welding Power Source
			using the disconnect switch at the fuse box
			Before connecting the wire feeder .
		ELECTRIC	Only qualified persons should install, use or
		SHOCK	service this machine .
		CAN KILL
		SPARE
	14 PIN	82		LN - 7
	AMPHENOL	81	N . C .	CONTROL
		42		BOX
N . C .		41
+		31	31
		32	32
CV -		2	2
		4	4
		21	21	K291 OR K404
TO		GND	GND	INPUT CABLE
	K867 UNIVERSAL		GREEN
WORK		75	75
	ADAPTER PLUG
		76	76
ELECTRODE CABLE		77	77	K775 OPTIONAL
TO LN - 7			N . D .
				REMOTE CONTROL
N . A . WELDING CABLE MUST BE SIZED FOR CURRENT

AND DUTY CYCLE OF APPLICATION .	N . F . WHEN MACHINE IS IN "REMOTE" MODE, A REMOTE
N . B . DIAGRAM SHOWS ELECTRODE POSITIVE . TO CHANGE
	OUTPUT CONTROL K775 IS REQUIRED .
POLARITY, TURN POWER "OFF", REVERSE ELECTRODE
	N . G . IF MACHINE IS IN "LOCAL" MODE, ELECTRODE IS
AND WORK CABLES AT POWER SOURCE .
	ALWAYS "HOT" .
N . C . INSULATE EACH UNUSED LEAD INDIVIDUALLY .
N . D . SPLICE LEADS AND INSULATE .
N . E . WELDER OUTPUT STUDS ON OPPOSITE SIDE FOR
CLASSIC II .
	S 2 1 0 3 6

NOTE: This diagram is for reference only. It may not be accurate for all machines covered by this manual. The specific diagram for a particular code is pasted inside the machine on one of the enclosure panels. If the diagram is illegible, write to the Service Department for a replacement. Give the equipment code number.